User manual SHARP EBR-90GKST BUILT-IN KIT INSTRUCTIONS

[. . . ] Disconnect the oven from the power supply before installation. Make sure that the EBR-90GKST is the correct surround for your oven. The Sharp Microwave Ovens are designed to either stand neatly on a kitchen counter top or to be built into a fitted kitchen cabinet using the surround. [. . . ] (For Australia) Do not install the microwave oven above a refrigerator or freezer. Fixing To avoid any possibility of the kitchen cabinet moving when the microwave oven is installed, it is essential that the kitchen cabinet is fixed to the back wall. Adjustment and repair It is dangerous for your oven to be adjusted or repaired by anyone except properly qualified service technicians trained by Sharp. If the appliance is ever removed from the cabinet it should be re-installed in accordance with these instructions, which should be kept in a safe place for future reference. The manufacturer and/or the distributors of this product cannot be held liable for any damages to the microwave oven and/or the built-in kit caused by improper installation or adjustment. The mains plug must be accessible after installation or an all-pole switch disconnection must be provided with a contact separation of at least 3 mm in each pole. (For Continental use) The electric outlet must be installed at 70 mm high from the floor of the built-in cabinet and at 280 mm from the right wall of the built-in cabinet as shown in Fig. Or the electric outlet should be provided in the shaded area as shown in Fig. The mains plug must be accessible after installation or the oven must be connected to an electric circuit provided with an all-pole switch (contact gap no less than 3 mm) to disconnect the oven in case of danger. A safety-device such as a fuse in the installation may be used as a switch. Caution : When the electric outlet is provided under the floor of the built-in cabinet, it should be where the power supply cord and plug of the microwave oven never touch an appliance installed below the microwave oven. Set the spacing bracket 1 on the shelf, keeping a distance of 29 mm between both side walls of the kitchen cabinet and the spacing bracket, and attach them with four screws 5, as shown in Fig. Caution: The arrow marks on each spacing bracket should be pointing towards you. Place the sash angle 2 along the upper edge of the kitchen cabinet, keeping a distance of 25 mm at either side of the sash angle 2. Attach it with 3 screws 5 from below the cabinet as shown in Fig. Install the oven into the kitchen cabinet. [. . . ] Set the lower built-in frame 4 into the built-in frame 3 and fasten them with 2 screws 7 (removed at step 8) from below as shown in Fig. Check the location by measuring the distance between each built-in frame element. 5 mm overlap at the bottom, ensuring there is no obstruction to adjacent cabinet doors, as shown in Fig. [. . . ]