User manual SHARP EBR-9910

[. . . ] Disconnect the oven from the power supply before installation. Make sure that the EBR-99ST/EBR-9900/EBR-9910 is the correct surround for your oven. The Sharp Microwave Ovens are designed to either stand neatly on a kitchen counter top or to be built into a fitted kitchen cabinet using the surround. The EBR-99ST/EBR-9900/EBR-9910 surround will become hot during oven operations when using the heater elements. [. . . ] If the appliance is ever removed from the cabinet it should be re-installed in accordance with these instructions, which should be kept in a safe place for future reference. The mains plug must be accessible after installation or an all-pole switch disconnection must be provided with a contact separation of at least 3 mm in each pole. (For Continental use) The electric outlet must be installed at 150 mm high from the floor of the built-in cabinet and at 50 mm from the right wall of the built-in cabinet as shown in Fig. The mains plug must be accessible after installation or the oven must be connected to an electric circuit provided with an all-pole switch (contact gap no less than 3 mm) to disconnect the oven in case of danger. A safety-device like a fuse in the installation may be used as a switch. Set the spacing brackets 1 on the shelf along the right and left walls of the kitchen cabinet, adjusting the front ends of the shelf and the spacing brackets, and attach them with the four screws B, as shown in Fig. Caution: The arrow marks on each spacing bracket should be pointing towards you. Place the exhaust duct 2 on the ceiling of the kitchen cabinet along the back wall of the cupboard D and left wall of the kitchen cabinet without the clearance as shown in Fig. Secure to the ceiling of the kitchen cabinet with two screws B from below as shown in Fig. Insert two tabs of the exhaust duct 2 into the slits of the exhaust duct 3. Remove the screw E from the oven as shown in Fig. Let the power supply cord pass through the hole of the lower side of the intake duct 4 as shown in Fig. Install the intake duct 4 to the rear of the oven with two screws C and E (removed at step 7) as shown in Fig. Caution: Avoid pinching the power supply cord between the oven and the intake duct 4. Caution: Avoid pinching the power supply cord between the oven and the intake duct 4. Remove the backing paper from the three cushions 7, 8 and 9. Attach the cushion 7 at the left side along the intake duct 4 then attach the cushion 8 at the top of the intake duct 4, and along the left side of the cushion 7 and the oven as shown in Figs. Use) Place the oven on a table/stand positioned in front of the kitchen cabinet. If you do not prepare the table/ stand, two persons are required. One to hold the oven whilst the other feeds the power supply cord through the prepared cut out. [. . . ] And secure the built-in frame element 0 through the holes of the built-in frame side elements A to the kitchen cabinet with two screws D as shown in Fig. 11, or the kitchen cabinet door may touch the built-in frame elements. Fixer le support 7 à la gauche du conduit d'aspiration 4 et fixer le support 8 au sommet du conduit d'aspiration 4, à la gauche du support 7 et du four, comme le montrent les figures 8-a et 8-b. La distance est indiquée à la figure 10. [. . . ]