User manual SHARP EL-1192BL

[. . . ] Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. The socket outlet shall be installed near the equipment and shall be easily accessible. PRE-TAX KEY DISPLAY SYMBOLS: M ­ E : Memory symbol Appears when a number is in the memory. [. . . ] Note: The decimal point floats during successive calculation by the use of or . If the decimal selector is set to "F" then the answer is always rounded down ( ). NON-ADD / SUBTOTAL KEY: Non-add ­ When this key is pressed right after an entry of a number in the Print mode, the entry is printed on the left-hand side with "#". This key is used to print out numbers not subjects to calculation such as code, date, etc. subtotal ­ Used to get subtotal(s) of additions and/or subtractions. When pressed following or , the subtotal is printed with "" and the calculation may be continued. CLEAR/CLEAR ENTRY KEY: Clear ­ This key also serves as a clear key for the calculation register and resets an error condition. Clear entry ­ When pressed after a number and before a function, clear the number. TOTAL KEY: When pressed after or , prints the total of addition and subtraction with "". EQUAL KEY: Gives the results of multiplication and division and performs repeat calculations with a constant. Multiplication: The calculator will automatically remember the first number entered (the multiplicand) and instruction. Division: The calculator will automatically remember the second number entered (the divisor) and instruction. There are several situations which will cause an overflow or an error condition. when this occurs , "E" will be displayed. The contents of the memory at the time of the error are retained. If an "0 E" is displayed at the time of the error, "­ ­ ­ ­ ­ ­ ­" will be printed in red and must be used to clear the calculator. When the integer portion of an answer exceeds 12 digits. When the integer portion of the contents of the memory exceeds 12 digits. Operating capacity: 12 digits Power source: AC: 120V, 60Hz Calculations: Four arithmetic, constant multiplication and division, power, add-on, tax, repeat addition and subtraction, reciprocal, grand total, item count calculation, markup, memory, etc. The rounding selector should be in the "5/4" position unless otherwise specified. [. . . ] (c) Damage caused or repairs required as a result of the use with items not specified or approved by Sharp, including but not limited to software, paper and batteries. (d) Any replacement of accessories, glassware, consumable or peripheral items required through normal use of the product including but not limited to batteries, AC adapters, ribbons, correction tapes, ink rollers, cables, printwheel, or paper. (e) Any cosmetic damage to the surface or exterior that has been defaced or caused by normal wear and tear. (f) Any damage caused by external or environmental conditions, including but not limited to transmission line/power line voltage or liquid spillage. [. . . ]