User manual SHARP EL-2630P

[. . . ] Appears when a number is in the grand total memory. Remove the paper roll from the calculator. (Tear the paper and remove it from the print mechanism by using . [. . . ] Always cut leading edge with scissors first. 1) Insert the leading edge of the paper roll into the opening. 1) 2) Turn the power on and feed the paper by pressing . 2) 3) Insert the paper roll to the paper holder. DECIMAL SELECTOR: Presets the number of decimal places in the answer. in the ``F'' position , the answer is displayed in the floating decimal system. CONSTANT/ADD MODE SELECTOR: ``K'': The following constant functions will be performed: Multiplication: The calculator will automatically remember the first number entered (the multiplicand) and instruction. Division: The calculator will automatically remember the second number entered (the divisor) and instruction. When the Add mode is activated, the decimal point is automatically positioned according to the decimal selector setting. Use of , and will automatically override the Add mode and decimally correct answers will be printed at the preset decimal position. There are several situations which will cause an overflow or an error condition. when this occurs , "E" will be displayed. The contents of the memory at the time of the error are retained. If an ``0 E'' is displayed at the time of the error, must be used to clear the calculator. If an ``E'' with any numerals except zero is displayed, the error may be cleared with or and the calculation can still be continued. When the integer portion of an answer exceeds 12 digits. When the integer portion of the contents of the memory exceeds 12 digits. Note: The decimal point floats during successive calculation by the use of or . [. . . ] Using the calculator with the voltage selector improperly set will cause damage to the unit. *: Press to clear the memory before starting a memory calculation. The socket outlet shall be installed near the equipment and shall be easily accessible. [. . . ]