User manual SHARP EL1197PIII

[. . . ] The use of If the decimal selector is set to "F" then the answer is always rounded down ( ). : Appears when a number is in the grand total memory. Remove the paper roll from the calculator. ) remove it from the print mechanism by using 2. [. . . ] If an ``E'' with any numerals except zero is or and the displayed, the error may be cleared with calculation can still be continued. also , in rare cases , printing may stop midway and the indication "E" appear on the display. This is not a malfunction but is caused when the calculator is exposed to strong electromagnetic noise or static electricity from an external source. Should this occur, press key and then repeat the calculation from the beginning. Each time this key is pressed, the mode switches. When the integer portion of an answer exceeds 12 digits. When the integer portion of the contents of the memory or grand total memory exceeds12 digits. PAPER FEED KEY LAST DIGIT CORRECTION KEY GRAND TOTAL KEY CLEAR ENTRY KEY TOTAL KEY: , to print the set tax Press this key twice, followed by rate. Time for battery replacement Life of the memory protection battery is approximately 2, 500 hours at 25°C(77°F) with the power plug not connected to the socket. * When the memory protection battery is weak, the date/time setting is initialised (1/1/2005, 12:00:00 a. Verify the date/time setting in the date/clock display mode when connecting the power plug to the socket. If the date/time setting is modified or incorrect, promptly replace the memory protection battery with new one. (The life of the pre-installed battery may be shorter than expected because of the time the calculator spends during shipment. (see "GRAND TOTAL / RATESETTING MODE SELECTOR") * When the adjustment is complete, the clock starts at 3:38:00 p. Key 1) The counter will count the number of times that the has been pressed in addition. Key is used in subtraction, 1 will be Note: · Each time the subtracted from the count. The count is printed when the calculated result is obtained. 2) When the grand total/rate setting mode selector is in the ON position (GT), the counter will count the number of times that the calculation results have been stored in the grand total key. To print and clear the count, press the 3) The memory item counter will count the number of times that key has been pressed in the addition. the Note: · Each time the key is used in the subtraction, 1 will be subtracted from the count. The count is printed when the memory is recalled. If the count exceeds the maximum, the counter will recount from zero. [. . . ] Strong impacts, exposure to electrical fields, or other unusual conditions may render the unit inoperative, and pressing the keys will have no effect. If this occurs, you will have to press the RESET switch on the bottom of the unit. The RESET switch should be pressed only when: · Pressing the RESET switch will clear the set date and time configuration, as well as conversion rate, tax/discount rate, and memory contents. Do not use anything breakable or anything with a sharp tip, such as a needle. [. . . ]