User manual SHARP ER-A250

[. . . ] Please read this Manual carefully before operating your machine in order to gain full understanding of functions and features. Please keep this manual for future reference, it will help you, if you encounter any operational problems. Install your register in a location that is not subject to direct radiation, unusual temperature changes, high humidity or exposed to water sources. The register should not be operated by an individual with wet hands. [. . . ] If you perform the operation with the substitution of "A=2" first, you cannot perform the operation with the substitution of "A=1". If you perform the operation with the substitution of "A=3" first, you cannot perform the operation with the substitution of "A=1" and "A=2". The details of the automatic register system modification are as follows: (As for PGM functions described below, please refer to "Programming EURO system settings" for "Printing exchange total amount and change amount on receipt or journal" and "Exchange calculation method", "Programming function parameters for e key" for the number of digits after decimal point of exchange amount, "Programming exchange currency symbol" for exchange currency symbol, and "Programming domestic currency symbol" for domestic currency symbol. Setting the EURO symbol ( ) for the currency symbol of exchange key, and setting "2" for the number of After the execution of the procedure with the substitution of "1", treat EURO as foreign currency using the exchange key (e) with the preset rate entry. Changing the domestic currency symbol to the EURO symbol ( ) and setting the number of digits after decimal point of the domestic currency amount to 2 7. For the setting of the currency symbol and the number of digits after decimal point of exchange amount, the ones that had been set to the domestic currency are set. Setting the round-off function for currency exchange After the execution of the procedure with the substitution of "2", treat EURO as domestic currency, and national currency as foreign currency using the exchange key (e) with the preset rate entry. Since EURO becomes domestic currency in your register after execution of the procedure with the substitution of "2", you must change unit prices in each department and PLU to make prices correspond to EURO before actually you start operating your register again. As for the miscellaneous keys, also please change the rates or amounts so that they are based on amounts in EURO. Changing the domestic currency symbol to the EURO symbol ( ) and setting the number of digits after decimal of the domestic currency amount to 2 7. Setting the round-off function for currency exchange After the execution of the procedure with the substitution of "3", treat EURO as domestic currency. When the function is in the OFF status, the receipt off indicator "_" illuminates. Your register will print reports regardless of the receipt state, so the paper roll must be installed even when the receipt state is "OFF". Cashier assignment Prior to any item entries, cashiers must enter their cashier codes into the register. However, the code entry may not be necessary when the same cashier handles the next transaction. When the time which is programmed has passed under the condition that no entry nor operation is performed, your register will enter the power saving mode. When your register goes to the power saving mode, it will light off all the display except the decimal point at the leftmost position. Your register will return to the normal operation mode when any key is pressed or a mode is changed with the mode key. However, please note that when your register is recovered by a key entry, its key entry is invalid. So, after the recovery, start the key entry from the beginning. In the following examples, your register will go into an error state accompanied with a warning beep and the error symbol " " on the display. Clear the error state by pressing the c key and take proper action. [. . . ] the 5-denomination coin case is also detachable from the till. To detach the drawer, pull it forward fully with the till removed, and remove it by lifting it up. However, when power failure is encountered or the machine becomes out of order, slide the lever located on the machine bottom in the direction of the arrow. ) The drawer will not open, if it is locked with a drawer lock key. [. . . ]