User manual SHARP FO-330

[. . . ] 24 average pages with no voice messages recorded and ECM turned off, or 20 minutes of voice messages (including OGMs) with no documents in memory) 14, 400 bps with automatic fallback to lower speeds. 6 seconds (only when ECM is on) Horizontal: 8 pels/mm Vertical: Standard: 3. 85 lines/mm Fine /Halftone: 7. 7 lines/mm Super fine: 15. 4 lines/mm 10 pages max. (Letter/A4, 80 g/m2 paper) Thermal transfer recording 64 levels MR, MH, MMR Approx. 50 Letter/A4 size sheets (at room temperature; maximum stack height should not be higher than the line on the tray) Legal: 5 sheets Memory size* Modem speed Transmission time* Resolution Automatic document feeder Recording system Halftone (grayscale) Compression scheme Paper tray capacity (60 - 80 g/m2 paper) *Based on Sharp Standard No. 1 Chart at standard resolution is Sharp special mode, excluding time for protocol signals (i. e. , ITU-T phase C time only). 1 Display 16-digit LCD display Applicable telephone line Public switched telephone network Compatibility Input document size ITU-T (CCITT) G3 mode Automatic feeding: Width: 148 to 216 mm Length: 140 to 297 mm Manual feeding: Width: 148 to 216 mm Length: 140 to 600 mm 210 mm max. [. . . ] If you were attempting to fax, make sure a document is in the feeder. If you were receiving, contact the faxing party to see how they are trying to send to you. 72 Printing Lists Transaction Report print condition You can change the condition under which a Transaction Report is printed out. Follow the steps below. 1 2 3 4 Display: Press FUNCTION once and once. OPTION SETTING Press once and twice. TRANSACTION Press once. 1:ALWAYS PRINT (Selections appear alternately) Press a number from 1 to 5 to select the condition for printing. 1 2 3 ALWAYS PRINT ERROR/MEMORY SEND ONLY ERROR ONLY NEVER PRINT A report will be printed after each transmission, reception, or error. A report will be printed after an error or a memory operation. A report will be printed after each transmission. A report will be printed only when an error occurs. A report will never be printed. The display briefly shows your selection, then: 4 5 DIAL MODE 5 Press STOP to return to the date and time display. 73 7. Maintenance Print head Clean the print head frequently to ensure optimum printing performance. Note: Remove the paper from the paper tray before cleaning the print head. 1 Unplug the telephone line and then the power cord, and open the operation panel (press ). 2 1 2 Take the imaging film out of the print compartment and place it on a sheet of paper. 3 Wipe the print head with isopropyl alcohol or denatured alcohol. Caution! · Do not use benzene or thinner. Avoid touching the print head with hard objects. · The print head may be hot if your fax machine has just received a large number of documents. · Make sure that the receiving machine has paper. · Make sure that the telephone line cord is plugged into the TEL. · If the receiving machine is in manual mode with no attendant, reception will not be possible. · Check the display for error messages. · Pick up the handset and check for a dial tone. Nothing is printed at the receiving end. A distorted image is received at the other end. · Make sure that the document for transmission is placed face down in the feeder. · Noise on the telephone line may cause distortion. · Make a copy of the document on your fax machine. If the copy is also distorted, your fax machine may need service. 78 Problems and Solutions Reception and copying problems 9. [. . . ] ) · . ( · . . . · . ) () LIGHT . ( ) () LIGHT · . ( . / . ) · . ( . [. . . ]