User manual SHARP FO-DC500

[. . . ] WARNING - FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user’s authority to operate this equipment. Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. [. . . ] 8 The ”Configure Standard TCP/IP Port Monitor” window will appear. Select LPR for the protocol, and enter any name for the queue name. Book Page 126 Thursday, May 13, 2004 8:51 AM Installing the Printer Driver 9 Click the Next button. 10 11 12 13 14 Check your settings and then click the Finish button. Insert the PRINTER UTILITIES CD-ROM into your CD-ROM drive. If the “Readme First” window appears, click Cancel to close the window. Enter the path Q:\Option\English\2kxp_pclxl (substitute the letter of your CD-ROM drive for “Q”) and click the OK button. The printer driver name will appear in the Add Printer Wizard. Book Page 127 Thursday, May 13, 2004 8:51 AM Installing the Printer Driver 15 Follow the instructions on your screen. When the “Printer Sharing” window appears, select Share as. If you would like to change the name, enter a new name (this must be 8 characters or less to allow sharing with Windows 98/Me computers). 16 Enter a location and comment if desired, click Next, and then follow the instructions on your screen to finish installing the printer driver. €¢ If the following window appears at any time, click Yes to continue the installation. Book Page 128 Thursday, May 13, 2004 8:51 AM Installing the Printer Driver Windows NT Server 1 2 The first step is to install Microsoft TCP/IP Printing. Click the Windows Start button, point to Settings, and then click on Control Panel. In the Control Panel window, double-click Network to open the Network window. If “Microsoft TCP/IP Printing” already appears in the list, close the Network window and go to Step 6. If “Microsoft TCP/IP Printing” does not appear, click the Add button. Book Page 129 Thursday, May 13, 2004 8:51 AM Installing the Printer Driver 4 5 6 7 8 9 Insert your Windows NT Server 4. Make sure the correct path is entered and click the Continue button. Follow the instructions on your screen to install the component. The next step is to install the printer driver using the Add Printer Wizard. [. . . ] Make sure that SET is Normal Dialing 1. lift extension phone or press SPEAKER selected. Dial the fax number (if using an extension phone, dial on the extension phone keypad). Wait for the reception tone (if a person answers, ask them to press their Start key). [. . . ]