User manual SHARP FO-DC635

[. . . ] WARNING - FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user’s authority to operate this equipment. Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. [. . . ] 124 Installing the Printer Driver Network types There are two types of networks, a peer to peer network where you print directly to the printer without going through a server, and a client-server network where you print through a server. Follow the appropriate instructions below for your operating system and your network type to install the printer driver. Client-server network: Installing the printer driver on the server To use the printer on a client-server network, the printer driver must first be installed on the server (this must be done before installing the printer driver on client computers). Follow the appropriate procedure for your server's operating system. Note: Printing is not possible on a client-server network that uses Windows Server 2003 Web Edition as there is no printer sharing function. ) 1 Windows 2000 Server: Click the Windows Start button, point to Settings, and then click on Printers. Windows Server 2003: Click the Windows Start button and then click on Printers and Faxes. Double-click Add Printer in the Printers window to run the Add Printer Wizard and then click Next. select Local printer attached to this computer (Local Printer in Windows 2000). Make sure that “Automatically detect and install my Plug and Play printer” is not selected and click Next. Network Printer Windows 2000 Server / Windows Server 2003 Installing the Printer Driver 4 Select “Create a new port” and select “Standard TCP/IP Port” from the list. Enter the IP address of the printer (the port name is filled in automatically). € If you need to check the IP address, follow the procedure in Printing out the Network Settings on page 82. Make sure that the printer has been turned on and has been configured for network printing, and then click the Next button. 126 Installing the Printer Driver 7 Select Custom and then click the Settings button. 8 The ”Configure Standard TCP/IP Port Monitor” window will appear. Select LPR for the protocol, and enter any name for the queue name. Network Printer Installing the Printer Driver 9 Click the Next button. 10 11 12 13 14 Check your settings and then click the Finish button. Insert the PRINTER UTILITIES CD-ROM into your CD-ROM drive. If the “Language Selection” window appears, click Cancel to close the window. Enter the path Q:\Option\English\2kxp_pclxl (substitute the letter of your CD-ROM drive for “Q”) and click the OK button. [. . . ] Press and then or until ENTRY MODE is selected in the display. Make sure that SET is Normal Dialing 1. lift extension phone or press SPEAKER selected. Dial the fax number (if using an extension phone, dial on the extension phone keypad). [. . . ]