User manual SHARP GB/GU-X18JR/X24JR/X36JR

[. . . ] Attention: If you want to dispose of this equipment, please do not use the ordinary dust bin!Used electrical and electronic equipment must be treated separately and in accordance with legislation that requires proper treatment, recovery and recycling of used electrical and electronic equipment. Following the implementation by member states, private households within the EU states may return their used electrical and electronic equipment to designated collection facilities free of charge*. In some countries* your local retailer may also take back your old product free of charge if you purchase a similar new one. [. . . ] ensure that there is no obstacle for the air intake and exhaust of the outdoor unit. If there is any obstacle blocking the air intake or exhaust, remove it. â· Place of installation shall be strong enough to support the weight of outdoor unit, and it shall be able to insulate noise and prevent vibration. Ensure that the wind and noise from the unit will not affect your neighbors. Place of installation must be able to drain the rainwater and defrosting water. â· Place of installation must ensure the machine will not be buried under snow or subject to the influence of rubbish or oil fog. â· The installation site must be at a place where the air exhaust outlet does not face strong wind. Ensure that the top hanger frame has enough strength to support the weight of the unit. â· The drainage pipe shall be easy to drain water. â· There shall be no obstacle at the inlet and outlet so as to keep the air in good circulation. The indoor unit, outdoor unit, power cord and connection cable shall be kept m at least from the TV set or radio. This is to prevent image interference and noise on above appliances. Installation of indoor unit () Insert a M0 expansion bolt into the hole. Refer to the profile dimensions drawing of the indoor unit for the distance between the holes. The preparation of all pipes (connecting pipes and drainage pipes) and cables (connecting lines of wire controller, indoor unit and outdoor unit) must be ready before the installation, so as to achieve smooth installation. Maybe it is required to support the ceiling to ensure the evenness of it and avoid the vibration of it. Consult with the user or a construction company for details. â· In case the strength of ceiling is not enough, use angle iron sections to set up a beam support. Check of the indoor unit level After the indoor unit is installed, be sure to check the level of the whole unit. The unit must be placed horizontally, but the condensate pipe shall be installed obliquely, so as to facilitate the drainage of condensate. As the inside of the unit is in the negative pressure status, it is required to set up a backwater elbow. the requirements is: A=BP/10+20(mm) P is the absolute pressure inside the unit. [. . . ] The yellow-green two-color wiring of air conditioner is grounding wire and can not be used for other purposes. It cannot be cut off and be fixed by screw, otherwise it would cause electric shock. Cable connecting diagram of unit The section area of cables selected by users must not be smaller than the specifications shown diagram. Outdoor unit Indoor unit Outdoor unit Indoor unit If your air-conditioning unit suffers from abnormal operation or failure, please first check the following points before repair: possible Reasons . [. . . ]