User manual SHARP GS-XPM7FR/XPM9FR/XPM12FR

[. . . ] Attention: If you want to dispose of this equipment, please do not use the ordinary dust bin!Used electrical and electronic equipment must be treated separately and in accordance with legislation that requires proper treatment, recovery and recycling of used electrical and electronic equipment. Following the implementation by member states, private households within the EU states may return their used electrical and electronic equipment to designated collection facilities free of charge*. In some countries* your local retailer may also take back your old product free of charge if you purchase a similar new one. [. . . ] ⷠThe display indicates "AM 6:00" when batteries are properly installed. The battery life is approximately one year in normal use. ⷠWhen you replace the batteries, always change both batteries, and make sure they are the same type. ⷠIf the remote control does not operate properly after replacing the batteries, take out the batteries and reinstall them again after 30 seconds. ⷠIf you will not be using the unit for a long time, remove the batteries from the remote control. Point the remote control towards the unit's signal receiver window and press the desired button. The unit generates a beep when it receives the signal. ⷠMake sure there is no curtain or other object between the remote control and the unit. ⷠThe remote control can send signals from up to 7 metres away. Do not allow the signal receiver window to receive strong direct sunlight, since it can adversely affect its operation. If the signal receiver window is exposed to direct sunlight, close a curtain to block the light. ⷠUsing a fluorescent lamp with a quick starter in the same room may interfere with transmission of the signal. ⷠThe unit can be affected by signals transmitted from the remote control of a television, VCR or other equipment used in the same room. ⷠDo not leave the remote control in direct sunlight or near a heater. Also, protect the unit and remote control from moisture and shock which can discolour or damage them. Example: 5 o'clock in the afternoon 1 To set to the 12-hour mode, press the CLOCK button once in the first step. To set to the 24-hour mode, press the CLOCK button twice in the first step. The current time cannot be set when the timer is operating. In the AUTO and DRY modes, the temperature can be changed C in 1°C increments within the range of 2°C higher to 2°C lower (Example: 2°C lower) from the temperature automatically determined by the air conC ditioner. ⷠIn the COOL and HEAT modes, the temperature can be set within the range of 18 to 32°C In the DRY mode, the fan speed is preset to AUTO and cannot be changed. To turn off the unit, press the ON/OFF button again. This air conditioner is a multi-type, and multiple indoor units are connected to one outdoor unit. [. . . ] ⷠIn the HEAT operation, water vapour may flow out of the outdoor unit during de-icing. Carpet and furniture odors that entered into the unit and the air conditioner's inner component odors at the early stage of installation may be sent out from the unit. After stopping the operation, the outdoor unit will rotate its fan for about a minute to cool down the unit. This sound is generated by the friction of the front panel and other components expanding or connecting due to a temperature change. [. . . ]