User manual SHARP HT-SL75

[. . . ] Hänvisa till sidorna i till vi och V-1 till V-12. TV timer mode or OAD (Over Air Download)) at STAND-BY position, the unit may be brought into operation. warning: This unit contains no user serviceable parts. Never remove covers unless qualified to do so. [. . . ] Slot in the sound bar to the base stand according to your TV size. (For model HT-SL70) (For model HT-SL75) 46" (117 cm) TV 176 mm (6 - 15/16”) RIGHT 52" (132 cm) TV 60" (152 cm) TV 70" (177 cm) TV Groove to neatly arrange the wire in. 336 mm (13 - 7/32”) Groove to neatly arrange the wire in. Caution: Be careful not to fix the bracket upside down. E-5 1 2 3 4 5 6 7 1 9 2011 October 7 HT-SL70 System preparation (continued) Caution: ● Be very careful to prevent the sound bar from falling when mounting on the wall. ● Before mounting , check the wall strength. (Do not put on the veneer plaster or whitewashed wall. — Check all wall mount angle screws for looseness. If not, accidents may occur or the sound bar may get damaged. — SHARP is not responsible for accidents resulting from improper installation. — Do not let children dangle on the sound bar once it is attached on the wall as it can cause damage and injury. – 4 Screw the wall mount angle to the wall as shown in the illustration. (Total screw is 4 pieces) Wall mount angle Wall mount angle (screws x 2) Wall surface (screws x 2) Note: Make sure all screws are fully tightened. (screws are not supplied) ■ Driving screws Installing the sound bar wall mount angle. SHARP designed the sound bar so you may hang them on the wall. 22 mm (7/8" ) ■ 1 Align the wall mount slot at the sound bar to the 2 Slot the sound bar into the wall mount angle. Wall surface Fixing wall mount angle position as below. Wall surface 1 Fix the pattern paper to the wall in horizontal Falling prevention Pattern paper 2 Make a hole on the wall following the screw point marks on the pattern paper by using a drill. 32 mm (1-1/4") 8-9 mm (3/8") Wall surface Safety wires (not supplied) are useful to prevent the sound bar from falling off the table. 3 Fix a wall mount plug (not supplied) into the hole using a hammer, until it is flush with the wall surface. 32 mm (1-1/4") 8-9 mm (3/8") Wall surface Loop the safety wires (not supplied) into each hole as shown and tie the safety wires to the LCD TV stand. E-6 1 2 3 4 5 6 7 8 9 10 2011 October 7 HT-SL70 ZB056 Placing the system Installation image: Notes: ● As the sound from the system is omni-directional, you TV can place the speaker anywhere you like. [. . . ] ● Is the HDMI cable connected correctly?— Is the HDMI cable of the correct type being used?(with ARC) ● Does the sound input support PCM signal?— Do not connect or disconnect an HDMI cable while power is on. [. . . ]