User manual SHARP K71V28BM2

[. . . ] Home Appliances Cooking EN User Manual FR Guide D’utilisation DE Bedienungsanleitung IT Istruzioni per l’uso For Life Dear Customer, Our goal is to offer you high-quality products that exceed your expectations. Your appliance has been produced in modern facilities and has been carefully tested for quality assurance. This manual is prepared in order to help you use your appliance, which has been manufactured using the latest technology, with confidence and maximum efficiency. Before using your appliance, carefully read this guide which includes basic information on safe installation, maintenance and use. [. . . ] CHOOSING A PLACE FOR THE OVEN ––There are several points to pay attention to when choosing a place for your oven. Make sure to take into account our recommendations below in order to prevent any problems and dangerous situations that could occur later!€“–When choosing a place for the oven, , make sure that there are no flammable or combustible materials in the close vicinity, such as curtains, oil, cloth etc. €“–Furniture surrounding the oven must be made of materials resistant to heat exceeding the room temperature by 50C°. EN -8- Required changes to wall cabinets and exhaust fans above the built-in combined product as well as minimum heights from the oven board are shown in Figure 1. The exhaust fan should be at a minimum height of 65 cm from the cooktop. If there is no exhaust fan, the height must be at least 70 cm. 2x Minimum 42 cm Minimum 42 cm Insert the oven into the cabinet by pushing it forward. Open the oven door and insert 2 screws in the holes located on the oven frame. When the product frame touches the wooden surface of cabinet, tighten the screws. 555m m If the oven is installed under a hob, the distance between the worktop and the top panel of the oven must be minimum 50 mm and the distance between the worktop and the top of control panel must be minimum 25 mm. WIRING AND SAFETY OF BUILTIN OVEN The instructions given below must be followed without fail during wiring: ––Screw the earthing cable at the earthing mark. supply cable connection must be as shown in Figure 6. If there is no earthed outlet conforming to regulations in the installation environment, call your authorized service supplier immediately. €“–The earthed outlet must be close to the appliance. €“–The supply cable should not contact the product’s hot surface. 5mm 576 mm 575 mm mm 595 595 mm 595 mm ––In case of any damage to the supply cable, make sure to call your authorised service supplier. The cable must be replaced by your authorised service supplier. €“–Wiring of the appliance must be performed by your authorised service supplier. €“–Faulty wiring may damage the appliance. This type of damage will not be covered under the warranty. €“–The appliance is designed to connect to 220-240V – if your electricity is different than the value given above, call your authorised service supplier immediately. [. . . ] Pending on usage, it is recommended that you replace them after a certain period of time. MAINTENANCE SERVICE AND TRANSPORT REQUIREMENTS BEFORE CONTAINING TO SERVICE If the oven does not operate: Replacing the Oven Light Only an authorised technician should change the oven light. The rating of the bulb should be 230V, 25 watt, Type E14, T300. Before changing the lamp, the oven should be unplugged and it should be cool. [. . . ]