User manual SHARP LC-60LE635E/RU/LE636E/S

[. . . ] REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. ENGLISH 1 IMPORTANT INFORMATION CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. CAUTION: DO NOT PLACE THIS PRODUCT ON AN UNSTABLE CART, STAND, TRIPOD, BRACKET, OR TABLE. THE PRODUCT MAY FALL CAUSING SERIOUS PERSONAL INJURY AND SERIOUS DAMAGE TO THE PRODUCT. USE ONLY WITH A CART, STAND, TRIPOD, BRACKET, OR TABLE RECOMMENDED BY THE MANUFACTURER OR SOLD WITH THE PRODUCT. FOLLOW THE MANUFACTURER'S INSTRUCTIONS WHEN INSTALLING THE PRODUCT AND USE MOUNTING ACCESSORIES RECOMMENDED BY THE MANUFACTURER. [. . . ] Page 43 No Signal Off . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 44 No Operation Off . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 44 Power Control Setup Power Management . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 44 EZ Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 37 CH Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Pages 37, 38 Antenna Setup-DIGITAL . . . . . . . . . . . . . . . . . . . . . . . Page 38 Input Label . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 61 Parental CTRL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Pages 68-73 Position . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 58 Picture Flip . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 61 Standby Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Pages 52-57 Basic adjustment settings EZ Setup You can run EZ Setup again, even after setting up the preset channels. Channel Setup If initial setup does not memorize all the channels in your region, follow the instructions below to manually memorize the channels. Language setting Select from among 3 languages: English, French and Spanish. Antenna setting 1 2 Press MENU and the MENU screen displays. 1 2 3 Press MENU and the MENU screen displays. Press c/d to select "Setup". Press c/d to select "Setup". 3 Press a/b to select "EZ Setup", and then press ENTER. If you already set the Secret No. , go to step 4. If not, skip to step 5. Press a/b to select "CH Setup", and then press ENTER. If you already set the Secret No. , input the 4digit secret number here. See page 68 for setting a secret number. 4 5 Input the 4-digit secret number by using 0 9. 4 5 Press a/b to select "Air/Cable", and then press ENTER. Press c/d to select "Air", "Cable", for ANALOG, then press b to move down. Press c/d to select, "Standard", "HRC", "IRC" for DIGITAL (Cable). Press ENTER to enter the setting. Press a/b to select the desired language listed on the screen, and then press ENTER. Antenna setting Make sure what kind of connection is made with your TV when selecting "Air" or "Cable" for ANALOG and DIGITAL (Cable). NOTE Make sure what kind of connection is made with your TV. There are 3 kinds of CATV system, including Standard, HRC and IRC. Select the one matches to your TV. 6 Press c/d to select "Air", "Cable", for ANALOG, then press b to move down. Press c/d to select "Standard", "HRC", "IRC" for DIGITAL (Cable). Press ENTER to enter the setting. There are 3 kinds of CATV system, including Standard, HRC and IRC. If cable or antenna connection was selected for the ANALOG IN terminal at the time when you set up TV Guide On Screen, the analog settings cannot be changed afterward. [. . . ] Nor shall Sharp be liable or in any way responsible for any incidental or consequential economic or property damage. Some states do not allow the exclusion of incidental or consequential damages, so the above exclusion may not apply to you. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS. YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE. [. . . ]