User manual SHARP LL-T1520/T1620

[. . . ] 10 Connecting the monitor and turning the monitor on and off . WARNING ­ FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user's authority to operate this equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] After completing the adjustments, press the computer's [Esc] key to exit the Adjustment Program. Notes: - If your computer's display mode is set to 65K colors, you may see the different color levels in each color pattern or the gray scale may look colored. Horizontal flicker noise H-POS (horizontal positioning) and V-POS (vertical positioning) To center the screen image within the boundaries of the screen, adjust the left-right (H-POS) values and the up-down (V-POS) values. Adjustments can be made using On Screen Display (OSD) Menu provided. CLOCK The figure below demonstrates how to adjust so that vertical flicker noise is not emitted. If you are using Windows, open the Adjustment Pattern on the accompanying Utility Disk. 18) If your system is not Windows, you can not use the Adjustment Pattern. Therefore display an image that makes the entire screen light and adjust it through checking visually its actual tone. This chapter provides the procedure how to adjust the screen by using Adjustment Pattern (for Windows) Vertical flicker noise PHASE The figure below demonstrates how to adjust so that horizontal flicker noise is not emitted. ( buttons) Notes: - Adjustments to PHASE should be made only after CLOCK has been correctly set. At this point relevant menu options can be adjusted. Each time the MENU button is pressed the next menu is selected. - To choose a menu option: SELECT button - To go to the next menu: MENU button - To choose a menu option: SELECT button - To go to the next menu: MENU button * Auto Gain Control function - The Auto Gain Control adjusts contrast and black level based on the brightest color of the image displayed. Unless an Adjustment Pattern is used, automatic adjustment may not be possible. in such a case , either use an Adjustment Pattern , or adjust manually. - If the signal coming from the computer is composite sync or sync on green, automatic adjustment cannot be performed. please perform manual adjustment instead. BLACK LEVEL Total screen brightness can be adjusted while watching the color pattern. Notes: - To choose a menu option: SELECT button - To go to the next menu: MENU button COLOR MODE Color tone can be set as below. sRGB : sRGB is international standard of color representation specified by IEC (International Electrotechnical Commission). Color conversion is made in taking account of liquid crystal's characteristics and represents color tone close to it original image. STD : Displays image with the color tone results from original scheme of liquid crystal panel. [. . . ] Klicken Sie auf [General], und wählen Sie unter [Compatibility] die Option [Apply the new display setting without restarting]. This equipment complies with the requirements of Directives 89/336/EEC and 73/23/EEC as amended by 93/68/EEC. Cocher la case [Display a list of all the drivers in a specific location, so you can select the driver you want. Cocher la case [Display a list of all the drivers in a specific location, so you can select the driver you want. [. . . ]