User manual SHARP LL-T1610W

[. . . ] Connecting the monitor and turning the monitor on and off . WARNING ­ FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user's authority to operate this equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] Using the ColorSync on the control panel, choose the profile to be used. Turning the power off If the monitor is not going to be used for a long period of time, be sure to unplug it from the AC outlet. Run signal cable and USB cable through here To replace it follow step 8 of Connecting the monitor to a power source on page 12. Connecting the monitor and turning the monitor on and off About screen adjustment The method of adjustment differs depending on whether the analog signal or the digital signal is being used. 20) For digital signal The monitor can generally be used without adjustment. The OSD contents are saved even after the power is turned off. However, if the power is turned off while the OSD menu is displayed, the contents are not saved. Setting the lock) any attempted changes to adjusted values will be avoided. Press the power button to turn off the monitor power. While pressing the MENU button, press the power button (i. continue to press the button until the message appears on the screen. When the menu is unlocked: [ADJUSTENT LOCKED] will appear on the screen, and the lock will be set. When the menu is locked: [ADJUSTENT UNLOCKED] will appear on the screen, and the lock will be removed. note: · When the lock is in place, all buttons other than the power button are disabled. Resetting all adjustment values All adjustment values can be returned to their original exfactory values in one command. Press the power button to turn off the monitor power. Press the MENU button and the SELECT button simultaneously, and while doing this press the power button (i. After the reset has been completed, press the power button to turn off the power. After a period of several seconds press the power button to turn the monitor back on. notes: · While [ALL RESET] is displayed, the control buttons do not function. It is not possible to reset values when the adjustment lock is in place. Choosing a language for messages Messages displayed on the screen and OSD Menu contents can be changed to the following languages. [. . . ] Aktivieren Sie [Display a list of all the drivers in a specific location, so you can select the driver you want. This equipment complies with the requirements of Directives 89/336/EEC and 73/23/EEC as amended by 93/68/EEC. Placer l'adaptateur secteur dans le support Rouler le câble de l'adaptateur secteur et le placer dans l'extrémité droite du support 5. Cocher la case [Display a list of all the drivers in a specific location, so you can select the driver you want. [. . . ]