User manual SHARP LL-H1513 OPERATION MANUAL

[. . . ] LCD MONITOR MONITEUR LCD MONITOR LCD MONITOR LCD !"==== ! LL-H1513 OPERATION MANUAL MODE D'EMPLOI MANUAL DE FUNCIONAMIENTO MANUAL DE INSTRUÇÕES !" Table of Contents Notice for Users in the USA . 10 Height adjustment, angle adjustment, rotation (long height/width) . 11 Connecting the monitor and turning the monitor on and off . 12 Connecting the monitor to a computer . [. . . ] (ADJUSTMENT GAIN CONTROL COLOR CONTROL MODE SELECT OSD Menu disappears) Note: - The OSD Menu automatically disappears approximately 30 seconds after the last command. Vertical flicker noise PHASE The figure below demonstrates how to adjust so that horizontal flicker noise is not emitted. ( buttons) Note: - Adjustments to PHASE should be made only after CLOCK has been correctly set. Horizontal flicker noise H-POS (horizontal positioning) and V-POS (vertical positioning) To center the screen image within the boundaries of the screen, adjust the left-right (H-POS) values and the up-down (V-POS) values. ( buttons) Screen frame 19 Adjusting the screen display (When using an analog signal) GAIN CONTROL Menu GAIN CONTROL MANUAL BLACK LEVEL CONTRAST 50 18 AUTO COLOR CONTROL Menu COLOR CONTROL COLOR MODE WHITE BALANCE HUE SATURATION sRGB 0 0 STD VIVID INPUT-1 1024 x 768 ANALOG V : 60Hz H : 48. 4kHz INPUT-1 1024 x 768 ANALOG V : 60Hz H : 48. 4kHz MANUAL: Individual menu options are manually adjusted. AUTO: Every menu option is automatically adjusted using the Auto Gain Control* function. Notes: - Press the button to select [AUTO]. - To choose a menu option: SELECT button - To go to the next menu: MENU button * Auto Gain Control function - The Auto Gain Control adjusts contrast and black level based on the brightest color of the image displayed. Unless an Adjustment Pattern is used, automatic adjustment may not be possible. In such a case, either use an Adjustment Pattern, or adjust manually. - If the signal coming from the computer is composite sync or sync on green, automatic adjustment cannot be performed. Please perform manual adjustment instead. BLACK LEVEL Total screen brightness can be adjusted while buttons) watching the color pattern. ( Notes: - To choose a menu option: SELECT button - To go to the next menu: MENU button COLOR MODE Color tone can be set as below. sRGB : sRGB is international standard of color representation specified by IEC (International Electrotechnical Commission). Color conversion is made in taking account of liquid crystal's characteristics and represents color tone close to it original image. STD : Displays image with the color tone results from original scheme of liquid crystal panel. VIVID : Displays an image with dynamic and VIVID primary colors. - If [sRGB] or [VIVID] has been selected, items subsequent to [WHITE BALANCE] cannot be set. Subsequent items can be set when the [COLOR MODE] is [STD]. WHITE BALANCE After selecting [WHITE BALANCE], press the button and display the adjustment menu. WHITE BALANCE COOL R-CONTRAST G-CONTRAST B-CONTRAST STD WARM USER Color pattern CONTRAST While watching the color pattern, adjustments can be made so that all graduations appear. ( buttons) OK [ MENU ] Notes: - On settings other than [STD] not all graduations can be displayed. To display all graduations, set to [STD]. - Use the buttons to select [COOL], [·], [STD], [·], [WARM] or [USER]. [. . . ] - While following these instructions, please also refer to the installation instructions in the operation manual included with the arm or stand. Turn off the monitor's power and unplug AC plug from AC outlet. Spread out a soft cloth on a suitable horizontal surface. Being careful not to damage the monitor, gently lay the monitor on it display-side down. CAUTION! [. . . ]