User manual SHARP MD-MT161E

[. . . ] Customers without internet access may telephone 08705 274277 during office hours (or (01) 676 0648 if telephoning from Ireland). [. . . ] 4 Close the compartment door. When you record on a MiniDisc, check that the erase prevention tab is set to the "recordable" position. 2 Lift it up. Recordable Recording prevented Web-site: www. sharp. co. uk/support Help Line: 08705 274277 (office hours) 2 Connect the AC adaptor AC 230-240V, 50/60 Hz 1 To the wall socket. 2 To the DC IN 5V socket. Insert securely, all the way in. 1 Plug the AC adaptor into the 2 Insert the plug on the other wall socket. end into the DC IN 5V socket. Before using the unit with a rechargeable battery, the battery has to be charged. Refer to "Battery Power", page 28 - 29 (operation manual) for details. Web-site: www. sharp. co. uk/support Help Line: 08705 274277 (office hours) 3 Connections OPTICAL/ LINE IN White: To Left Red: To Right LINE OUT To a stereo system with "LINE OUT" or "AUDIO OUT" sockets. Note: If the audio system has only one pair of sockets they are usually for input only and recording via this connection is not possible. RIGHT LEFT NOTE: Refer to page 11 (operation manual) for connecting the unit to a stereo system with "DIGITAL OUT" or "OPTICAL OUT" socket. Web-site: www. sharp. co. uk/support Help Line: 08705 274277 (office hours) Preparation for use The unit does not work if the unit is in the hold mode. Press the HOLD button for 2 seconds or more. Hold Release CAUTION: It is not recommendable to put the MiniDisc into a rear pocket, as this may damage the product when sitting. Web-site: www. sharp. co. uk/support Help Line: 08705 274277 (office hours) Recording Check that the unit is connected to the stereo system. 1 Press the REC button. Record pause mode is entered. 2 Begin playback on the stereo system connected to this portable MD. To enable the record level to be set. 3 Press the 5 or 4 button to adjust the recording level. Adjust the recording level so that the maximum sound volume from the source makes the reading swing somewhere between ­4 dB and 0 dB. During this process "TOC" will flash and "TOC EDIT!" will be displayed. During any recording or editing function the MiniDisc unit lid is locked, the MiniDisc can not be removed until the process is finalised. Warning: If the power is removed (Battery/AC adaptor) whilst "TOC" is displayed the MiniDisc unit lid will remain locked until the battery/main power is restored and the unit is turned on. Your new recordings or edited changes will be lost and your MiniDisc may become unusable. To update the recorded contents of the MiniDisc Press the s / :OFF button whilst in the stop mode. q The power turns off after recorded contents have been updated on the MiniDisc. Web-site: www. sharp. co. uk/support Help Line: 08705 274277 (office hours) Playback 1 Insert the earphones plug firmly into the earphones socket on the remote control unit. 2 Plug the remote control into the REMOTE socket on the unit. [. . . ] 4 Press the PLAY/PAUSE button. Playback starts automatically with a playback only MiniDisc or a MiniDisc which is protected against accidental erasure (Auto-play function). To stop playback Press the s / :OFF button. If the unit is not operated for at least 2 minutes whilst in the stop mode, the power will shut off automatically. [. . . ]