User manual SHARP MD-S301H2

[. . . ] Warning: To prevent fire or shock hazard, do not expose this appliance to dripping or splashing. No objects filled with liquids, such as vases, shall be placed on the apparatus. CAUTION: At full power prolonged listening to a personal stereo may damage the user's hearing. The model is in compliance with the law in case of using it with the SHARP earphones (model number RPHOH0004AWZZ). [. . . ] Z To use a microphone, be sure it is a plug-in-power type microphone. - When a plug-in-power type microphone is plugged in , the portable MD will provide power for the microphone's operation. - If a different type of microphone is plugged in, it may not operate properly or it may cause the unit to malfunction. If you don't, the recording will not be made properly. Z If the unit starts recording too often from low unwanted noises, set the microphone input to "MIC SYNC L". Z Recording sensitivity can be changed whilst recording. MIC SYNC H : Recording starts when the unit detects ---24 dB or more (The unit can start recording from quiet sounds). Recording starts when the unit detects --- 12 dB or more. When a sound, such as person speaking, is picked up by the microphone, recording will begin automatically. When recording from the microphone, track numbers will be created automatically at regular intervals (default setting: approximately every 5 minutes). During a mic synchro recording, the unit pauses when a silence lasts for 3 seconds or more, and creates a track number. When the unit is used in a place exposed to much vibration, sound skipping can be decreased by cancelling the auto power save function. Auto power save function automatically adjusts the sound skip memory storage to be from 5 to 10 seconds depending on playback conditions, this saves battery power. If the MiniDisc unit is used in areas of much vibration, it may be necessary to fix the sound skip memory to 10 seconds "Psave OFF". This will improve performance under difficult conditions but uses more power. (When the AC/car adaptor is used the 10 second mode is always used. The digital recording level you set will be kept even after cancelling recording. Every time you cancel recording, the level will return to [D. A playback only or recording prevented MiniDisc cannot be edited. The first 3 characters in the group of the selected characters will be displayed for about 1 second. Z The unit will enter the character input mode. To enter more letters, repeat steps 3 - 5. [. . . ] Z Is the AC adaptor unplugged or did a power failure occur whilst recording or editing?Z Is an optical signal being output from the stereo system?When the operation buttons are pressed, the unit does not respond. When this product is subjected to strong external interference (mechanical shock, excessive static electricity, abnormal supply voltage due to lightning, etc. [. . . ]