User manual SHARP MD-X3

[. . . ] The range of dates that can be entered is from January 1, 1997 to December 31, 2099. If recorded tracks are fast reversed or fast forwarded, the sound may skip. The total of the recorded time and time remaining on a disc may not add up to the maximum possible recording time. In the MD system, the delimiter of the recording area on an MD is programmed in a TOC. If partial erasing, recording and editing are repeated several times, TOC information will fill up, even though the number of tracks has not reached the limit (255 tracks), and further recording will be impossible. (If you use the all erase function, this MD can be used from the beginning. ) If there is any flaw on the MiniDisc, that part is automatically excluded from the space available for recording. [. . . ] Whilst recording an MD, you cannot set the date and clock. Be sure to set the date and clock before recording. POSSIBLE CAUSE Did a power failure occur? REMEDY Try setting it again. Set this unit to the stand-by mode and then turn it back on. Is the volume level is set to "0"?When a radio or TV which uses an indoor aerial is placed near the unit, the picture on the TV screen may be distorted or the radio may not function properly. It is recommended that you use an external aerial. 8 Resetting the date and time: Once you have set the date and time, "TIME ADJUST" will not be displayed in step 2. Turn the jog dial to make the date and time appear. If you don't need to change the settings, just press the ENTER button without turning the jog dial again. 9 Checking the date and time: Press the TIMER/DELETE button. Then turn the jog dial until the date and time are displayed. Press the DISPLAY button to switch between the date and the time. Radios make unusual noise or the picture on the TV screen is distorted. 10 Time setting mode CD playback SYMPTOM Even though a disc has been loaded, "NO DISC" or "ERR" is displayed. Playback stops in the middle of a track, or playback is not performed properly. Slide the accidental erase prevention tab back to its original position. Put in another recordable disc with recording space on it. Place the unit on a firm, level surface free from vibration. Is the MiniDisc protected against accidental erasure?Did you try to make recording on a playback-only MiniDisc? Replace it with a regular disc that can be copied. Change the stop position of the track and then try editing it. Can you see the "TOC FULL" message in the display? Even though a disc has been loaded, "NO DISC" or "ERR" is displayed. Playback sounds are skipped. The disc is very dirty. Is the unit located near excessive vibrations?Has condensation formed inside the unit? Can't T REC CH ERROR CONNECT ERR Remove the disc and leave the power turned on. The unit should function properly in about 1 hour. Set this unit to the stand-by mode and then back to on, and press the button. Make sure the cable is connected correctly and that power is being supplied to the portable MD player. Reload the disc or replace it. Tape recording and playback SYMPTOM REMEDY Cover the accidental erase prevention hole. Clean the capsten and pinch roller. POSSIBLE CAUSE DEFECT Din UNLOCK DISC ERR Wait until the power is supplied. A recording cannot be made. Is the tape protected against accidental erasure? Sound is skipped. The tape is damaged. Sound in high-frequency range cannot be reproduced. [. . . ] Set this unit to the stand-by mode and wait for a while. Replace it with another disc. (Continued) If a problem occurs TOC FULL (:Number or symbol) TOC W ERROR TRAY ERROR U TOC ERR (:Symbol) U TOC W ERR There is no space left for recording character information (track names, disc names, etc. ). TOC information recorded on the MD does not match the MD specifications or it cannot be read. The TOC information could not be created properly due to a mechanical shock or to scratches on the disc. [. . . ]