User manual SHARP MICROWAVE OVEN INSTALLATION INSTRUCTIONS

[. . . ] If the wall is not flat, use spacers to fill in the gaps. Wall construction should be a minimum of 2" x 4" wood studding and 3/8" or more thick dry wall or plaster/lath. The mounting surfaces must be capable of supporting weight of 110 pounds--the oven and contents--AND the weight of all items which would normally be stored in the top cabinet above the unit. The unit should be attached to a minimum of one 2" x 4" wall stud. [. . . ] Pull the louver away from the unit and set aside. Loosen the two Mounting Screws (D) which secure the Mounting Plate to the rear side of the oven. See Figure 7. Mounting Plate (A) (B) (C) Mounting Plate (D) (D) Control Panel Side Figure 6 Figure 7 8 VENTILATION SYSTEM This Microwave Oven/Hood is designed for adaptation to three types of hood ventilation systems. Select the type required for your installation. Recirculating requires the use of the Charcoal Filter 9 (previously installed or is packed in the packing foam). Horizontal Exhaust -- outside ventilation. Vertical Exhaust -- outside ventilation. (A) RECIRCULATING: Non-Vented, Ductless Operation The unit is shipped assembled for recirculating. Attach the Charcoal Filter to the upper side of the oven by sliding into the tabs. The Exhaust Damper Assembly 8 is not required for recirculating operation. The Charcoal Filter should be replaced every 6 to 12 months, depending on use. The Charcoal Filter RK-230 is also sold as an accessory . See page 8 for ordering information. 9 Tabs Tabs Figure 8 4 (B) HORIZONTAL EXHAUST: Outside Ventilation 1. Remove and save 2 screws from back edge and 1 screw from the top center of Fan Cover Bracket. Remove Fan Cover Bracket by sliding it in the opposite direction of the arrow on the Fan Cover Bracket, as shown in Figure 9. Withdraw Hood Fan Unit carefully and slip wires out of Wire Box. CAUTION: Do not pull or stretch hood fan wiring. Rotate the Hood Fan Unit and turn end-over-end so that the fan blade openings are facing the back of the oven. Be careful not to pinch the lead wire between the inner bracket and the Hood Fan Unit. Replace the Fan Cover Bracket by sliding it into the slits in the same direction as the arrow on the Fan Cover Bracket. Make sure the fan blades are visible through the rear openings in the oven before proceeding. Attach Fan Cover Bracket to unit with 3 screws, which were removed in Step 1 above. [. . . ] Make sure the unit has been installed according to all of the Installation Instructions, the Top Template and Wall Template. Remove all packing material from the oven. Keep the Installation Instructions for the local electrical inspector's use. ACCESSORIES 1. Filter is used when hood exhaust is recirculated only. [. . . ]