User manual SHARP MOBILON HC-4100 OPERATION MANUAL

[. . . ] MODEL OPERATION MANUAL Safety Warning on Internal Fax/Modem Never install telephone wiring during a lightning storm. Never install a modular jack in a wet location unless the jack is specifically designed for wet locations. Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface. Use caution when installing or modifying telephone cables. [. . . ] Enter a new location, or tap Browse to select one. Note: If you want Voice Recorder to always start with the default folder open, check the appropriate checkbox. 46 Data exchange with other devices via IR You can exchange data with other devices such as SHARP ZR Series units, using infrared communication. The following tables indicate the type of data you can exchange. Your unit Contacts Explorer Your unit Image Editor ZR Series unit Contact1 PC Files IrTran-P device (depends on the device) How much data One or more contacts One file How much data One JPEG file Note: IrTran-P is a standard for transferring image files via IR. By using this function, you can exchange image files with various devices that support the IrTran-P standard. Sending data from your unit The following uses Contacts as an example. Align your unit and the receiving unit so that their infrared ports are facing each other. 2. 3. On your unit, highlight the desired data. Set the receiving unit to the receiving mode. In the case of SHARP ZR Series unit, press the GET key. 47 4. On your unit, tap Send from the File menu, then select ZR Series. Note: For Explorer files, select a file in step 2. In step 4, tap File, Send To, and Infrared Recipient to send the file. 48 Notes on field mapping when sending data to a ZR Series unit PC files are sent as they are without any conversion. For Contacts data, the following rules apply: Contacts data on the unit is converted to Contact1 data on the ZR Series unit. Restrictions on data sizes differ between the two units. On your unit, there is a field size limit. On the ZR Series unit, the record size must be less than 2048 bytes but there is no limit on the field size. When data is received on the ZR Series unit, data exceeding the 2048 byte limit is truncated. Since the name information on your unit is stored in several fields, they are mapped into one single field on the ZR Series unit as follows: Your unit Mr/Ms/Dr Suffix First Middle Last ZR Series unit Mr/Ms/Dr/[SP]First[SP]Middle[SP]Last[SP]Suffix Your unit uses more fields in storing address information than the ZR Series unit. Therefore the fields are mapped as follows: Your unit Street City State ZIP Country ZR Series unit Street[CR] City, [SP]State[SP]ZIP[CR] Country The Name field on the ZR Series unit is always required. If this field is empty, then the ZR Series unit will store it as Untitled. 49 Receiving data to your unit The following uses contacts as an example. Align your unit and the sending unit so that their infrared ports are facing each other. 2. 4. On the sending unit, highlight the desired data. On your unit, tap Receive from the File menu, then select ZR Series. Set the sending unit to the sending mode. In case of SHARP ZR Series unit, press SEND key, then start receiving the data. 50 Notes on field mapping when receiving data from ZR Series unit PC files are received as they are without any conversion. [. . . ] Any Sharp product tampered with, modified, adjusted or repaired by any party other than Sharp, Sharp's Authorized Service Centres or Sharp's Authorized Servicing Dealers. Damage caused or repairs required as a result of the use with items not specified or approved by Sharp, including but not limited to software, paper and batteries. Any replacement of accessories, glassware, consumable or peripheral items required through normal use of the product including but not limited to batteries, AC adapters, ribbons, correction tapes, ink rollers, cables, printwheel, or paper. Any cosmetic damage to the surface or exterior that has been defaced or caused by normal wear and tear. [. . . ]