User manual SHARP PA-VR10E

[. . . ] Never use the earphones or operate the digital voice recorder while driving a car or riding a motorcycle or bicycle. Doing so could result in a traffic accident. While walking, never turn up the volume so high that you cannot hear what is going on around you. Doing so could result in fire, damage or malfunction. [. . . ] If the current recording contains event marking numbers, the next event marking number is displayed and playback begins from that number. Displays the previous file number and starts playback from the beginning of that file. 5 4 Hold down the 1 (5) or 0 (4) cursor button and select the file number to be deleted. Hold down the ERASE button for 1 second or longer. The remaining file numbers are adjusted after the file is deleted. deleting during playback · Follow steps 3 and 4 above while the file number appears on the display. Hold down the ERASE button for approximately 5 seconds or longer. Automatic recording function This function enables you to automatically make a recording at a set time by specifying the start and end times. Press the STOP/MENU button once or twice to display the menu screen. Press the L (+) or M (-) cursor button until the "SCHED" (automatic recording function) screen appears, then press the OK button. Use the same procedure to select the hour and minute settings for the end time. after you have confirmed the "minutes" setting , press the OK button. This completes the time setting procedure and returns you to the menu screen. Settings such as the recording mode and microphone sensitivity used for scheduled recording are those that were set before recording begins. ⷠIf the scheduled time is reached while you are playing a recording, playback stops and the recorder starts recording. ⷠIf the scheduled time is reached while the digital voice recorder is connected to a personal computer, a flashing indication appears on the display and recording does not take place. Message alarm function This function enables the recorder to play a pre-recorded message or sound an alarm tone at a set time. Press the STOP/MENU button once or twice to display the menu screen. Press the L (+) or M (-) cursor button until the "ALARM" (message alarm function) screen appears on the display, then press the OK button. (1) A "REC 3, 2, 1" countdown appears on the display, followed by "START" to indicate that you should begin recording the message. The recorded message can be up to 15 seconds long. (2) When you have finished recording the message, the "MSG" display flashes and the recorder plays back the recorded message. [. . . ] If neither of the above apply, try the reset procedure. If the "FULL" indication is displayed, try deleting some unwanted files. Nothing happens when any button is pressed. The duration of the recorded audio is shorter than the actual recording time The beginning of the recording is cut off. [. . . ]