User manual SHARP PC-1403

[. . . ] (Read the service condition of the software before use. ) SHARP assumes no responsibility for problems caused by incorrect handling, repairs, defects, battery replacement or any other cause. i Notice for Users in the USA FCC Statement WARNING - FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user's authority to operate this equipment. Note: This equipment have been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Read the message and then, click Yes or No. For the second use and later; · · When Yes is chosen in the step 3 above, the Network Setup Utility will automatically run on Windows start-up. When No is chosen in the step 3 above, click start ­ All Programs - Network Setup Utility ­Network Setup Utility. Loading Network Settings To set your specific network setting, confirm that the computer is connected into the network and has the proper settings for your current environment and follow the instructions below. Confirm the current network setting is to be loaded. Run the Network Setup Utility to display the Network Setup Utility window. 7. Click OK in the confirmation window. In the Register an icon and network name dialog box, select the SHARP icon or Windows icon, then, click the Select icon button. The selected icon appears on the main screen of the Network Setup Utility window. It takes a moment to load and register the network settings. Using or Switching to Network Using or Switching to Loaded Network To use or switch the loaded network, confirm the computer is ready to connect into the network and follow these steps. Run the Network Setup Utility to display the Network Setup Utility window. Select the appropriate network icon in the Network Setup Utility window. · Make sure the computer is connected to the proper environment. System Date defines the system date, using the format month/day/year. Use Enter key to move the cursor, and minus key or space bar to change numerals. Hard Disk Type defines the type of the hard disk of the computer. Internal NumLock defines whether the numlock keys of the built-in keyboard are always disabled or not. (Num lock indicator will turn when Fn+NumLk are pressed regardless of this setting. An external keyboard will be numlocked if connected. ) Quiet Boot defines whether the SHARP logo appears on the screen while booting. CPU Information shows the information on the CPU. System Memory shows the volume of the conventional memory used in MS-DOS. Extended Memory shows the volume of the extended memory more than 1MB. The displayed volume is the result with the volume for CMS subtracted. BIOS Version shows the BIOS version of the system EC/KBC Version shows the EC/keyboard controller version of the system. [. . . ] Select "Temporarily Allow Pop-ups" or "Always Allow Pop-ups from this site. . . ". "Always Allow Pop-ups from this site. . . " will always allow for the permitted site to have pop-up ads. Start up the Microsoft Internet Explorer. · 1. 2. If you want to have pop-up ads on the specified web site; Start up the Microsoft Internet Explorer. [. . . ]