User manual SHARP PC-9820T

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · · · · Reorient or relocate the receiving antenna. Increase the distance between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] Arrow Facing Up Indicator 4 · Always insert a floppy disk straight into the floppy disk drive. · When inserting the disk, make sure it is not upside down. · Do not use excessive force when inserting the floppy disk. If you have difficulty inserting or removing disks, seek the assistance of an authorized service technician. · Do not touch the disk while reading/writing data. It may cause malfunction of your computer and the drive. Ejecting Floppy Disk Before ejecting the floppy disk, make sure the indicator of the floppy disk drive unit is not lit. Remove it and store it properly. Eject Button 4-4 Formatting Floppy Disk 1. Make sure the floppy disk is not write-protected, and insert it into the floppy disk drive. Right-click 3 ½ Floppy (A:) icon; then, click Format. . . Select the appropriate formatting options. · When you format a floppy disk, all data previously stored on the disk is lost. Speakers with an Amplifier Audio Output Jack Stereo Mini Plug 4-7 Connecting Digital Audio Equipment The audio output jack of your computer is compliant to S/PDIF (Sony/Philips Digital Interface). You can connect S/PDIF compliant audio equipment to your computer and output/record sound. S/PDIF Compliant Audio Equipment Audio Output Jack 4 S/PDIF Compliant Optical Audio Cable When recording sound with an audio equipment: · Use AC adapter for your computer and the digital audio equipment. · Exit other application programs. · Disable Windows power management. · Do not enter System standby/ hibernate. · Use the digital audio equipment compliant with sampling rate of 48kHz. · Sound may not be recorded correctly if you use the synchronized recording system of the digital audio equipment. 4-8 Connecting Analog Audio Equipment Audio Output Jack White (L) Red (R) Stereo Mini Plug Analog Audio Cable 4 You can adjust the output volume on Windows by sliding the volume lever appearing when clicking the speaker icon on the taskbar. Connecting Headphone Use the headphone with an impedance of 8 or more. (32 is recommended). Audio Output Jack Stereo Mini Plug 4-9 Connecting Microphone You can input sound using an external microphone connected to the microphone jack. Use an electret condenser microphone with an impedance of 2. 2k and an allowable voltage of 2V. Microphone Jack Mini Plug 4 To record sound: 1. Click start; then, point All Programs ­ Accessories ­ Entertainment. [. . . ] (To open Advanced dialog box, refer to Communicating with Other Computers section of Chapter 5. ) Adjust the distance between the computers by bringing your computer closer to others and remove any obstructions that may impede the communication; then, try to connect again. (The distance between computers or access points should be less than approximately 60m (190 feet), in direct line of sight. ) Confirm the IP address, the subnet mask and the default gateway of each computer are set correctly. Confirm the WEP key is correctly entered if the WEP security of other devices, which you want to communicate with, is enabled. · · Trouble with Peripherals Question: Why don't peripheral devices function? Question: Why can't I print? · · · · · · · Make sure the printer is turned on. Check whether your computer and the printer are connected correctly. [. . . ]