User manual SHARP PN-L702B

[. . . ] This equipment has been tested and found to comply with the limits for Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. [. . . ] ) If the monitor is in this mode and you press the POWER button on the remote control unit, the monitor enters standby mode. If the remote control is not available, you can turn on/off by pressing the power switch power LED with a sharp object (see page 8). INPUT (Input mode selection) Each time you press this button, the mode changes in the following order (see page 8): · dIGITAL ANALOG COMPONENT VIDEO DIGITAL. * If the remote control is not available, you can change the mode by pressing the input switch on the front panel of the monitor with a sharp object (see page 8). Press the MUTE button again to turn the sound back to the previous level. * If you do not press any buttons for about 4 seconds, the VOLUME menu automatically disappears. Sound is muted when volume is set to "0". * If you do not press any buttons for about 4 seconds, the BRIGHT menu automatically disappears. SIZE (Screen size selection) Each time you press this button, the screen size changes in the following order (see page 34): · wIDE ZOOM 1 ZOOM 2 NORMAL Dot by Dot WIDE. MODE (Screen mode selection) Each time you press this button, the screen mode changes in the following order: · The display disappears when you press this button again, or it disappears automatically after approximately 4 seconds. Menus can be displayed on the screen to enable video and audio adjustment and the setting of various functions using the remote control unit. 0 - 31 15 For more color intensity For less color intensity (Monochrome at "0") 0 - 31 15 For more sharpness For less sharpness COOL / · / STD / · / WARM STD Color tone bluer than standard Color tone slightly bluer than standard Color tone standard setting Color tone slightly redder than standard Color tone redder than standard [OFF TIMER] Function Specifies the remaining time before turning off the power (entering standby mode) (see page 21). How to adjust Use / to move menu screen. default Center [OSD V-POSITION] Function Adjusts the vertical display position of menu screen. How to adjust Use / to move menu screen. SET] Function Assigns ID numbers to monitors connected in a daisy chain (see page 38), using RS-232C cables. Adjustable range 0 - 255 Default 0 Note The numbers 1 to 255 are available for ID numbers. (If "0" is set, the system regards this as the state where no ID number is set. ) Although numbers up to 255 can be used for monitor IDs, the number of connectable monitors varies depending on the length of RS-232C cables and the installation environment. Adjustable range 0 - 15 Default 0 (Increasing the value makes the sub screen more transparent. If the main screen is displayed as a full screen by the AUTO OFF function, the sound for the main screen is output even when the sound for the sub screen is specified. Adjustable range PC/AV [MAIN POS] Specifies whether to display the main screen on the right or left in PbyP or PbyP2 mode. [. . . ] Are the batteries inserted with polarity ( , ) aligned?Make sure audio cables for external speakers are connected properly: left and right cables may be reversed or one of the two cables may not be connected. Make sure the volume is not set to minimum. When these terminals are used, make sure their audio cables are also connected. [. . . ]