User manual SHARP SD-AT50DV

[. . . ] warning: This unit contains no user serviceable parts. Never remove covers unless qualified to do so. This unit contains dangerous voltages, always remove mains plug from the socket before any service operation and when not in use for a long period. Q Warning: To prevent fire or shock hazard, do not expose this appliance to dripping or splashing. [. . . ] If the unit finds out a desired programme type, corresponding the station name will flash for 10 seconds and remain lit. If you want to listen to the same programmed type of another station, press the PTY-TI button whilst the channel number and station name are flashing. The unit will look for the next station. If no station can be found, "NOT FOUND" will appear for 4 seconds. If you select the traffic programme (TP) in step 4, "TP" will appear. (This does not mean that you can listen to the traffic information at that time. Before starting this operation, you must store one or more station names in memory. If the button is held down for more than 0. After the selected programme type has been lit for 2 seconds, "SEARCH" will appear, and the search operation will start. When the specified programme starts on an ON (other network) station, the unit will automatically switch to the station and "PTY" will flash. When the programme is over, the unit will automatically return to the original station. However, if the signals from all stations are weak or not good (due to electrical noise), the unit displays "WEAK SIG" and returns to the original station. "TP" Not lit Not lit Lit "TA" Not lit Lit Not lit Meaning Does not carry traffic announcements nor does it refer, via EON, to a programme that does. Carries EON information about another programme which gives traffic information. Carries traffic announcements but not at present and may also carry EON information about other traffic announcements. When you press the ON/STAND-BY button to enter the stand-by mode. When the unit is switched to another band in the EON stand-by mode. when you change the FM station whilst in the EON stand-by mode. The TOC (Table of Contents) is information on track numbers and recording areas to allow the unit to recognise musical selections or sounds. The entire MiniDisc is controlled depending on this TOC, which enables the unit to find the beginning of a track quickly or to automatically record in a vacant area. Area for TOC (recording track numbers, track names, etc. SHARP is not liable for damage or loss of your recording arising from malfunction of this unit. [. . . ] Move the AC power lead away from the aerial if located near. Playback stops in the middle or is not performed properly. Playback sounds are skipped, or stopped in the middle of a track. Is the unit located near excessive vibrations? [. . . ]