User manual SHARP SF-2314/2414/2514

[. . . ] In some areas, the "POWER" switch positions are marked "I" and "i" on the copier instead of "ON" and "OFF". The symbol "i" denotes the copier is not completely de-energized but in a stand-by condition at this "POWER" switch position. If your copier is so marked, please read "I" for "ON" and " i" for "OFF". CAUTION: For a complete electrical disconnection, pull out the main plug. [. . . ] The first copy can be made using any of the paper feed stations. Replace the first original with the second original and close the document cover. Make sure that the first and second originals are oriented in the same way on the document glass. Turn the first copy over without changing its top-bottom orientation and place it into the bypass tray. ⷠBe sure to feed the copies one sheet at a time. Use the TRAY SELECT (M) key to select the bypass tray. The automatic exposure level can be adjusted to suit your copying needs. This level is set for copying from document glass or from the SPF (SF-2514 only). NOTE: SF-2514 only When using document glass remove original from SPF tray. One or two exposure indicators corresponding to the automatic exposure level which has been selected will light up. Press the light ({) or dark (}) key to lighten or darken the automatic exposure level as desired. This automatic exposure level will remain in effect until you change it again by this procedure. Selection of this mode does not affect the photo (6) mode. Follow the procedure below for setting the toning level. To enter the toner save mode, press the light ({) key. ⷠThe exposure indicator marked "1" will light up, indicating the toner save mode is selected. ⷠTo return to the standard mode, repeat the procedure but use the dark (}) key to select exposure level "5" in step 3. When the misfeed (t) indicator blinks, the copier stops because of a misfeed. if a misfeed occurs in the paper tray , will blink. If paper is accidentally torn during removal, be sure to remove all pieces. be careful not to damage the photoconductive drum or corona wires. If a misfeed occurs when using the SPF, a number may appear in the copy quantity display after a minus sign ("­"). [. . . ] Do not load paper above the maximum height line. ⷠWhen adding paper, first remove remaining paper, combine it with the paper to be added and then reload as a single stack. Push the paper tray firmly back into the copier. Open the side cover of the paper feed unit and remove the misfed paper. [. . . ]