User manual SHARP UX-187A

[. . . ] This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and the receiver. [. . . ] Thank you for calling. " Try to keep the length of the message under 10 seconds. If it is too long, you may have difficulty receiving faxes sent by automatic dialing. If your outgoing message must be longer than 10 seconds, leave a pause of about four seconds at the beginning of the message. This will give your fax a chance to detect fax tones sent when automatic dialing is used. Activating the answering machine connection Before you go out, activate the answering machine connection as follows: 1 Set the reception mode to A. M. RECEPTION MODE TEL FAX A. M. 88 Connecting an Answering Machine 2 Set your answering machine to auto answer. Your answering machine must be set to answer on a maximum of two rings. If not, you may not be able to receive faxes sent by automatic dialing. If your answering machine has a toll saver function, make sure that it will answer by the fourth ring. Note: If your answering machine has a remote retrieval function, make sure the code used to activate remote retrieval is different from the code used to activate fax reception with an extension telephone (see page 75). If they are the same, entering the code from an outside telephone to retrieve messages will cause the fax machine to be activated. How the connection operates While you are out, all of your incoming calls will be answered by your answering machine and its outgoing message will play. During this time, your fax will quietly monitor the line. If your fax detects a fax tone or a duration of silence greater than four seconds, it will take over the line and begin reception. 89 7. Answering Machine When you return and turn off your answering machine, be sure to change the reception mode back to FAX or TEL! Optional A. M. Make sure that the telephone company has activated your service. Noise on the telephone line prevented reception of caller information. The call was made from an area which does not have a caller identification service, or the caller's service is not compatible with that of your local phone company. Caller information was not provided by the telephone company at the caller's request. CALLER-ID ERROR OUT OF AREA PRIVATE CALL 94 Caller ID 8. Special Functions HOLD/ SEARCH Viewing the Caller ID list If you subscribe to a Caller ID service and have turned on the Caller ID function, your fax machine will keep information on the most recent 20 calls and faxes you have received. You can view this information, which consists of the name and number of each caller, in the Caller ID List. After you have received 20 calls, each new call will delete the oldest call. Follow the steps below to view the Caller ID List in the display. If desired, you can immediately dial a number when it appears. 1 Press these keys: The display will show: REVIEWING CALLS 2 2 Press the * key to scroll through the list from the most recent call, or the # key to scroll through the list from the oldest call. or 3 If you want to dial one of the numbers in the list, scroll through the list until the number appears in the display. · If you want to send a fax, load the document and then press the START/MEMORY key. START/MEMORY 95 Caller ID · If you want to make a voice call, pick up the handset or press the SPEAKER key. (If you pressed the SPEAKER key, pick up the handset when the other party answers. ) 4 Press the STOP key when you have finished viewing the list. STOP To delete calls from the Caller ID list If you want to delete a single call from the caller list, press the 0 key while the call appears in the display. [. . . ] Regulatory Information NFPA Rating (U. S. A. ) WHMIS Legislation (Canada) Transport Information UN No. : : : : No information Not controlled No information No information Section 11. Other Information References : IARC(1996), IARC Monographs on the Evaluation of the Carcinogenic Risk of Chemicals to Humans, Vol. 65, Printing Process and Printing Inks, Carbon Black and Some Nitro Compounds, Lyon, pp-149-261 H. [. . . ]