User manual SHARP VZ-2500H

[. . . ] Batteries are not included. 1 Remove the battery cover. 2 Insert the batteries as shown. 3 Replace the cover. 1 Accessories 3 Removing the transport screw Before turning the power on, be sure to remove this transport screw on the back of the unit using a flat head screwdriver or a coin. Transport screw Remote control × 1 AM loop aerial ×1 FM aerial × 1 AC power lead ×1 ­1­ TINSE0104SJZZ 02D N TO 1 CDXP120HE_QG 1 02. 4. 10, 6:34 PM 4 System connections FM aerial AM loop aerial 5 Turn on your system The first time the unit is plugged in, the unit will enter the demonstration mode. You will see words scroll. Right speaker Left speaker 1 Press the EQUALIZER/X-BASS/ DEMO button to cancel the demonstration mode. 2 Press the ON/STAND-BY button to turn the power on. Wall socket (AC 230 V, 50 Hz) Plain White line ­2­ CDXP120HE_QG 2 02. 4. 10, 6:34 PM Listening to a CD (CDs) Listening to the radio 1 2 3 Press the CD button. [. . . ] Press the 7 OPEN/CLOSE button to open the disc tray. Place the CD(s) on the disc tray, label side up. When loading a third disc, press the DISC SKIP button to turn the disc tray, then place the CD in the open position. 12 cm (5") 8 cm (3") 1 2 Press the TUNER (BAND) button repeatedly to select the desired frequency band (FM or AM). Press the TUNING (X or W ) button to tune in to the desired station. X When the TUNING button is pressed for more than 0. 5 seconds, scanning will start automatically and the tuner will stop at the first receivable broadcast station. To receive an FM stereo transmission: Press the TUNER (BAND) button to display the "ST" indicator. q When cleaning the heads, pinch rollers, etc. , unplug the unit which contains high voltages. TAPE 1 A B C D Press the 0 button of TAPE 1 or TAPE 2 to start playback. A Erase head B Recording/ Playback head C Capstan D Pinch roller E Playback head s If trouble occurs When this product is subjected to strong external interference (mechanical shock, excessive static electricity, abnormal supply voltage due to lightning, etc. ) or if it is operated incorrectly, it may malfunction. If such a problem occurs, do the following: 1. Set the unit to the stand-by mode and turn the power on again. If the unit is not restored in the previous operation, unplug and plug in the unit, and then turn the power on. TAPE 2 E C D Note: If neither operation above restores the unit, clear all the memory by resetting it. q After long use, the deck's heads and capstans may become magnetised, causing poor sound. Demagenetise these parts once every 30 hours of playing/recording time by using a commercial tape head demagnetiser. [. . . ] If the unit is not restored in the previous operation, unplug and plug in the unit, and then turn the power on. TAPE 2 E C D Note: If neither operation above restores the unit, clear all the memory by resetting it. q After long use, the deck's heads and capstans may become magnetised, causing poor sound. Demagenetise these parts once every 30 hours of playing/recording time by using a commercial tape head demagnetiser. [. . . ]