User manual SHARP VZ-3500H/HB

[. . . ] 4 Names of Controls and Indicators . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-6 Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Useful Features Advanced Recording . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15-19 Recording from a Microphone . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] To charge the battery fully, continue charging for about 2 more hours. ( In this case, you do not need to press the :OFF/CHRG (·s ) button. Even if the :OFF/CHRG (·s ) button is " will not appear. ) pressed, " Notes: q This unit should only be used within the range of 0°C 40°C (32°F - 104°F). q Charge the battery within the range of 5°C - 35°C (41°F - 95°F). q Charging is completed when " " does not blink when you plug in the AC adaptor and press the :OFF/CHRG (·s ) button. q The unit can be left in the charging state after it is completed. Caution: q Use the specified battery AD-N70BT only. Do not charge a battery (nickel-cadmium, alkaline, etc. ) other than that specified. q Do not remove the outer cover of the rechargeable battery. It may cause heat generation, fire, or explosion. q Do not dip the battery in water, do not dispose of it in a fire, and do not take it apart. q If the rechargeable battery terminal is dirty, charging may not start. (Perform steps 1 - 2 on page 31. ) Press the VOL + or VOL ­ button to move the cursor to the right of the character, where you want to add a new character. To enter a space Press the VOL + button to move the cursor to the right. Space 3 KLMN , / Characters (symbols) Capital letters Select the character to add. (Perform steps 3 - 4 on page 31. ) ABCDEFGH Lower-case letters I J OPQRSTUVWXYZ. a o b c r d s e t 5 f u g h i j y 0 / k l z. : " ; 4 5 Press the ENTER/SYNC button. pq vwx 89 ­. mn , / #$ <= Press the EDIT button. Numbers and symbols 1234 %& ' ( ) >?@_ ` * 67 +, : indicates a space. 33 32 **05-ADVANCED FEATURES 33 02. 07. 2000, 10:04 AM Titling a MiniDisc : continued Advanced Features Stamping titles from another MiniDisc Before stamping When there are 2 MiniDiscs on which the same tracks are recorded, you can transfer the character information (disc and track names) of the Master MiniDisc to another MiniDisc (for stamping). Master MiniDisc operation 1 2 3 Insert a Master MiniDisc. Do not mistake the Master MiniDisc for the target one. 1. What is a master MiniDisc? A recordable MiniDisc that contains tracks and character information. (You can not transfer the information from a playback-only MiniDisc. ) Whilst in the stop mode, press the EDIT button to select "NAME STAMP". Press the ENTER/SYNC button. q To cancel the operation, press the · s/:OFF button. 2. What is a MiniDisc for stamping? A MiniDisc that contains the same tracks in the same order as the master MiniDisc. (Make sure that the total number of tracks of the master MiniDisc and the one for stamping are the same. ) 4 5 Press the ENTER/SYNC button. When the unit displays "CHANGE MD", remove the master MiniDisc. q Remove it without turning off the power. Or the operation will be cancelled. 33 34 **05-ADVANCED FEATURES 34 02. 07. 2000, 10:04 AM Titling a MiniDisc : continued Advanced Features Operation of the MiniDisc for stamping 6 Load a MiniDisc for stamping. Notes: q If the total number of tracks on the master MiniDisc does not match that on the MiniDisc for stamping, the unit will display "Can't STAMP" and turn off the power. 7 Press the ENTER/SYNC button. If this happens, adjust the total number of tracks on the newly recorded MiniDisc using the edit operation. q Use a MiniDisc that was recorded by this unit to make a MiniDisc for stamping. Character information may not be transferred if you use a MiniDisc recorded by other equipment. [. . . ] 14 Function Battery level . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26 Battery Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27, 28 Default settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 38 Hold function . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]