User manual SHARP XE-A107 FULL DETAILED

[. . . ] ELECTRONIC CASH REGISTER MODEL XE-A107 FULL DETAILED INSTRUCTION MANUAL CAUTION: The cash register should be securely fitted to the supporting platforms to avoid instability when the drawer is open. CAUTION: The socket-outlet shall be installed near the equipment and shall be easily accessible. VORSICHT: Die Netzsteckdose muß nahe dem Gerät angebracht und leicht zugänglich sein. ATTENTION: La prise de courant murale devra être installée à proximité de l’équipement et devra être facilement accessible. [. . . ] Reading/Resetting. Sales. Data In order to check sales, you can read a sales report. Also you should reset sales data after you practicing your cash register. To read a sales report, you should take an X report; set the mode switch to the X/Flash position, and press A. To reset sales, you should take a Z report; set the mode switch to the Z/PGM position, and press C. The sales data accumulated and the ground total (GT) is cleared. If you print a Z report without grand total (GT) resetting, press A. Set the mode switch to the X/Flash position. Press A. To. issue. a. Z. report. with. resetting. of. GT. (after. practicing): 1. Set the mode switch to the Z/PGM position. Press C. To. issue. a. Z. report. without. resetting. of. GT: 1. Set the mode switch to the Z/PGM position. 2. Press A. For reading and resetting of actual sales data, please refer to “Reading and Resetting of Sales” section on page 19. You should reset sales data at the end of each day to clear sales data. 12 Utilizing. Various. Features. for. Sales. Entries Before making sales entries, make sure that a paper roll is installed in case receipt function is on. Also make sure to turn the mode switch to the REG position. PLU. Entries Enter the PLU code of a PLU item and press p. The PLU item will be registered. Example Selling. a. PLU1. item. and. a. PLU15. item. by. credit. Key. operation. example . Receipt. print . 1p 15p c T NOTE o use PLU item sales entry, you must program PLUs. For the programming, refer to the “PLU Programming” section on page 23. 13 Convenient. Sales. Entries When. selling. only. item. by. cash. (Single Item Cash Sale (SICS) entry) When a sale is for only one item paid by cash, such as a pack of cigarettes, you can use SICS function. It is applicable only to department keys programmed for SICS or to PLUs associated with such departments. The drawer opens after pressing the department or PLU key. When. entering. more. than. one. of. the. same. department. or. PLU. items You can enter two or more of the same department or PLU item by pressing department or PLU key repeatedly (repetitive. entry), or by using the multiplication key (multiplication. entry). It will be convenient to use the multiplication key when selling the same item in bulk. For operation, refer to the example shown below. Example . Repetitive. entry Selling two 2. 00 items (dept. [. . . ] Then plug in the AC adapter, feed the roll paper to the proper position and press l. The register with then resume correct printing after printing “············”. 30 Before Calling for Service If you encounter any of the following problems, please read below before calling for service. Fault • The display does not illuminate. • The display shows symbols that do not make sense. [. . . ]