User manual SHARP XE-A407

[. . . ] These limits are designed to provide reasonable protection against harmful interference when this equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. CAUTION The socket-outlet shall be installed near the equipment and shall be easily accessible. FOR YOUR RECORDS Please record below the model number and serial number, for easy reference, in case of loss or theft. These numbers are located on the right side of the unit. [. . . ] Key operation example REG-mode entries Print 1500 # 250 - . . . Error l Turn the mode switch to the MGR position. 250 Return the mode switch to the REG position. A CORRECTION AFTER FINALIZING A TRANSACTION (Void mode) When you need to void incorrect entries that clerks cannot correct (incorrect entries found after finalizing a transaction or cannot be corrected by direct or indirect void), follow this procedure: 1. 2. Turn the mode switch to the VOID position using the manager key (MA), to enter into the void mode. Repeat the entries that are recorded on an incorrect receipt. (All data for the incorrect receipt are removed from register memory; the voided amounts are added to the void-mode transaction totalizer. ) REG OPX/Z OFF VOID PGM MGR X1/Z1 X2/Z2 Incorrect receipt Cancellation receipt 61 OPERATOR MAINTENANCE 1 In case of Power Failure When power is lost, the machine retains its memory contents and all information on sales entries. · When power failure is encountered in register idle state or during an entry, the machine returns to normal operation after power recovery. · When power failure is encountered during a printing cycle, the register prints "========" and then carries out the correct printing procedure after power recovery. (See the sample print. ) 2 In Case of Printer Error If the printer runs out of paper, the printer will stall, and "PPPPPPPPPP" will appear on the display. Refer to section 5 in this chapter, install a new roll, then press the l key. The printer will print the power failure symbol and resume printing. If the print head comes up, the printer stalls, "H" will appear on the extreme left of the display. Bring the print head back to the correct position, then press the l key. The use of any other paper rolls other than those specified could cause paper jamming, resulting in register malfunction. Paper specification Paper width: 57. 5 ± 0. 5 mm Max. outside diameter: 80 mm Quality: Thermal paper · Be sure to set paper roll(s) prior to using your machine, otherwise it may cause a malfunction. Be careful to set the roll and cut the paper end correctly. If the top end of the paper roll is fixed with paste or tape, the paper may lose its color development ability in the pasted or taped area due to the deterioration of the heat-sensitive color development component of the paper surface. This may result in nothing appearing at this location when printing. Therefore, when setting a new paper roll in the machine, be sure to cut off approximately one revolution (approx. (How to set the paper roll) To the printer To the printer (How to cut the paper end) Correct Incorrect Correct Incorrect 63 Removing the paper roll When a red dye appears on the paper roll, it is time to replace it. If you plan on not using the register for an extended period of time, remove the paper roll, and store it in an appropriate place. Caution: The paper cutter is mounted on the cover. When the take-up spool is not used: 1. [. . . ] · ¿Está el rollo de papel bien instalado?· ¿Hay algún atasco de papel?· ¿Está la función de recibos en el estado "OFF"?· ¿Está la palanca de liberación del cabezal de impresión en la posición de impresión? [. . . ]