User manual SHARP XE-A302

[. . . ] ELECTRONIC CASH REGISTER CAJA REGISTRADORA ELECTRONICA MODEL MODELO XE-A302 INSTRUCTION MANUAL MANUAL DE INSTRUCCIONES WARNING FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user's authority to operate this equipment. Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when this equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. [. . . ] Lift up the print roller release lever to unlock and open the print roller arm. 6. Remove the paper roll from the paper roll cradle. Do not pull the paper through the printer. 69 7. Remove the outer side of the take-up spool as shown on the left. 8. Remove the printed journal roll from the take-up spool. Installing the paper roll Caution: The paper cutter is mounted on the printer cover. Installing the receipt paper roll: Paper positioning guides 1. Turn the mode switch to a position other than OFF with the power cord connected. Lift up the print roller release lever to unlock and open the print roller arm. Set the paper correctly in the paper roll cradle. Feed the end of the paper along with the paper positioning guides. 6. While holding down the paper, slowly close the print roller arm, and push down the arm until you hear a click locking the arm. Make sure securely you push down the center of the wing part of the arm as illustrated at the left. If the print roller arm is not securely locked, printing is not done right. If this problem occurs, open the arm, and close the arm as instructed above. 7. Cut off the excess paper using the edge of the inner cover, and replace the printer cover. Press the key to make sure the paper end comes out of the printer cover and clean paper appears. If the paper end does not come out, open the printer cover, and pass the paper end between the paper cutter and the paper guide of the printer cover, and replace the cover. F 70 Installing the journal paper roll: 1. Turn the mode switch to a position other than OFF with the power cord connected. Lift up the print roller release lever to unlock and open the print roller arm. Set the paper correctly in the paper roll cradle. Feed the end of the paper along with the paper positioning guides. While holding down the paper, slowly close the print roller arm, and push down the arm until you hear a click locking the arm. Make sure securely you push down the center of the wing part of the arm as illustrated at the left. [. . . ] Haga el registro dentro del límite de registro. Haga una operación de importe recibido. Finalice la transacción y corrija las entradas erróneas en el modo de cancelación. Asegúrese de que el brazo del rodillo impresor esté bloqueado con seguridad. [. . . ]