User manual SHARP XE-A403

[. . . ] ELECTRONIC CASH REGISTER CAJA REGISTRADORA ELECTRONICA MODEL MODELO XE-A403 INSTRUCTION MANUAL MANUAL DE INSTRUCCIONES WARNING FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user's authority to operate this equipment. Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when this equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. [. . . ] If you plan on not using the register for an extended period of time, remove the paper roll, and store it in an appropriate place. Caution: The paper cutter is mounted on the printer (receipt side). Turn the mode switch to the REG position with the power cord connected. Cut the paper behind the printer and near the paper roll. Press the { key until the paper remaining in the printer comes out completely. 5. Remove the paper roll from the paper roll cradle of the receipt side. Do not pull the paper through the printer. Removing the journal paper roll: Area to cut 1. Turn the mode switch to the REG position with the power cord connected. Press the } key to advance the journal paper until its printed part is out of the way. 4. Cut the paper and remove the take-up spool. Cut the paper behind the printer and near the paper roll. Press the } key until the paper remaining in the printer comes out completely. 7. Remove the paper roll from the paper roll cradle of the journal side. Do not pull the paper through the printer. 65 8. Remove the outer side of the take-up spool as shown on the left. 9. Remove the printed journal roll from the take-up spool. Installing the paper roll Caution: The paper cutter is mounted on the printer (receipt side). Installing the receipt paper roll: 1. Turn the mode switch to the REG position with the power cord connected. Check that the print head release lever is in the printing position. Set the paper correctly in the paper roll cradle of the receipt side. Insert the end of the paper into the paper chute of the printer until it is caught by the printer auto-feed and comes out of the top of the printer. If the printer does not catch the paper, feed the paper while pressing the key. Cut off the excess paper using the paper cutter, and replace the printer cover. Installing the journal paper roll: { 1. [. . . ] Haga el registro dentro del límite de registro. Haga una operación de importe recibido. Finalice la transacción y corrija las entradas erróneas en el modo de cancelación. Mueva la palanca hacia el carrete de toma (a la posición de impresión). [. . . ]