User manual SHARP XL-540H

[. . . ] Micro sistemi XL-540H composto da XL-540H (apparecchio principale) e CPXL65H (sistema di diffusori). XL-540H micro systeem bestaande uit XL-540H (hoofdtoestel) en CP-XL65H (luidsprekersysteem). Sistema de micro componente XL-540H composto de XL-540H (unidade principal) e CP-XL65H (sistema de alto-falante). XL-540H Micro Component System consisting of XL-540H (main unit) and CPXL65H (speaker system). XL-540H BEDIENUNGSANLEITUNG MODE D'EMPLOI MANUAL DE MANEJO BRUKSANVISNING MANUALE DI ISTRUZIONI GEBRUIKSAANWIJZING MANUAL DE OPERAO OPERATION MANUAL DEUTSCH FRANAIS ESPAOL SVENSKA ITALIANO NEDERLANDS PORTUGUS ENGLISH Siehe Seiten i bis vi und D-1 bis D-26. Se reporter aux pages i vi et F-1 F-26. Consulte las pginas i a vi y S-1 a S-26. [. . . ] Wall Screws (not supplied) Notes: Unplug the unit if it is not to be used for a prolonged period of time. Never use a power lead other than the one supplied. Otherwise, a malfunction or an accident may occur. Preparation for Use External FM aerial: Use an external FM aerial if you require better reception. Consult your dealer. External FM aerial To turn the power on Press the ON/STAND-BY button to turn the power on. To set the unit to the stand-by mode: Press the ON/STAND-BY button again. 1 2 3 4 5 6 7 8 E-6 02/12/20 XL_55H_H_E1. fm XL-540H Remote control Battery installation 1 2 Remove the battery cover. Insert the supplied batteries according to the direction indicated in the battery compartment. When inserting or removing the batteries, push them towards the battery terminals. Replace the cover. ENGLISH Test of the remote control Face the remote control directly to the remote sensor on the unit. The remote control can be used within the range shown below: Press the ON/STAND-BY button. Now, you can enjoy the music. 3 Remote sensor Preparation for Use Precautions for battery use: Replace all old batteries with new ones at the same time. Remove the batteries if the unit is not to be used for long periods of time. Note: The "0:00" or time will flash when the AC power supply is restored after a power failure or unplugging the unit. To readjust the clock: Perform "Setting the clock" from the beginning. If the "0:00" is not flashing in step 1, step 2 (for selecting the 24-hour or 12-hour display) will be skipped. To change the 24-hour or 12-hour display: 1 Clear all the programmed contents. [Refer to "Clearing all the memory (reset)" on page 25 for details. ] 2 Perform "Setting the clock" from the beginning. 2 Within 1 minute, press the PRESET ( or ) button to select 24-hour or 12-hour display and then press the MEMORY button. "0:00" "AM 12:00" The 24-hour display will appear. (0:00 - 23:59) The 12-hour display will appear. (AM 12:00 - PM 11:59) Note that this can only be set when the unit is first installed or it has been reset. (Refer to "Clearing all the memory (reset)" on page 25. ) E-9 02/12/20 XL_55H_H_E2. fm Listening to a CD This system can play audio CD-R and CD-RW discs just like CD discs, but cannot perform recording. Playback of audio CD-R or CD-RW may not be performed depending on the disc state or the device you used for recording. XL-540H ENGLISH 1 2 3 4 Press the ON/STAND-BY button to turn the power on. Press the FUNCTION button until "CD STOP" appears on the display. When operating with the remote control, press the CD button. CD EJECT button to open the CD compart- Place a CD on the spindle, label side up. 5 Close the CD compartment by firmly pushing the corner marked "PUSH CLOSE". CD Playback Total number of tracks Total playing time 6 Press the ( ) button to start playback from track 1. When the last track on the disc has finished playing, the CD player will automatically stop. 1 2 3 4 5 6 7 8 E-10 02/12/20 XL_55H_H_E2. fm XL-540H Listening to a CD (continued) To interrupt playback: Main unit operation: Press the button. [. . . ] Wait until electricity resumes. " CD player Playback does not start. Is the disc loaded upside down? References No sound is heard. Is the volume level set to "MIN"? Cannot erase completely. Playback stops in !the middle or is not performed proper- ! [. . . ]