User manual SHARP XL505E OPERATION MANUAL

[. . . ] Should the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse marked or and of the same rating as above, which is also indicated on the pin face of the plug must be used. Always refit the fuse cover after replacing the fuse. Never use the plug without the fuse cover fitted. In the unlikely event of the socket outlet in your home not being compatible with the plug supplied, cut-off the mains plug and fit an appropriate type. [. . . ] q The clock starts operating from "0" seconds. (Seconds are not displayed. ) Note: q In the event of a power failure or when the AC power lead is disconnected, the clock display will go out. When the AC power supply is restored, the clock display will flash on and off to indicate the time when the power failure occurred or when the AC power lead was disconnected. Whilst the track number is flashing, turn the jog dial clockwise. q The track number will flash. 1 Press the RANDOM/REPEAT button. q Each time this button is pressed, the mode will change in the following order: Repeat play Random play Normal play (Remote control operation) Press the 2 4 button for less than 0. 5 seconds during playback. q To skip a number of tracks at one time, press the 5 3 or 2 4 button on the remote control repeatedly until the desired track number is shown. q To start playing at a desired track, press the 5 3 or 2 4 button on the remote control whilst in the stop mode to select the track number, and then press the 0 / CD 6 (0 6) button. 2 Press the playback. 0 / CD 6 (0 6) button to start s Cue and review To cancel repeat or random play: Press the RANDOM/REPEAT button until "R" or "RANDOM" disappears. 1 2 3 Load a disc and begin playback. Hold the 2 button down for audible fast forward, and hold the 3 button down for audible fast reverse. Normal playback will resume when the 3 button is released. 2 To repeat playback of selected tracks: After entering the programme for the tracks you want to hear using "APMS", select repeat play and start playback. Notes: q When using random play or repeat play, be sure to press the s button after you are through listening. Otherwise, the disc will play continuously. q During APMS operation, random play is not possible. or Notes: q When the end of the disc is reached whilst cueing, the "End" will appear in the display and CD operation is paused. (Metal or CrO2 tape is not recommended. ) For recording, use only normal tape. q Do not use C-120 tapes, tapes with large diameter reels, or poor-quality tapes, as they may cause malfunctions. q Before loading a tape into the cassette compartment, tighten the slack with a pen or pencil. q Cassettes have removable tabs which prevent accidental recording or erasing from taking place. Removing the tab will protect the corresponding side from being erased. Cover the tab holes with adhesive tape to erase or record again. Side A (1) Tab for side B (2) Tab for side A (1) s Tape playback 1 2 Press the ON/STAND-BY button to turn the power on. Press the FUNCTION button until "TP" appears in the display. Open the cassette door by pushing the area marked "7 PUSH EJECT". Load the cassette into the cassette compartment. Press the 1 2 5 q Press the TAPE button on the remote control. 3 4 5 0 button. 4 3 To stop playback: Press the s button. Fast forward/rewind: To advance the tape, press the s button, then press the button. [. . . ] q Be sure your headphones have a 3. 5 mm (1/8") diameter plug and are between 16 ohms and 50 ohms impedance. q When headphones are connected, the speakers are disconnected automatically. Adjust the VOLUME control for desired volume. If fingerprints or dust accumulate on the pickup, clean it gently with a dry cotton swab. [. . . ]