User manual SHARP XLHF202PHX OPERTIONMANUAL

[. . . ] — For device with a lower Android version, refer the operation manual of the device for recommended app (application). Hänvisa till sidorna i till viii och V-1 till V-22. Pdf ● Hereby, SHARP Electronics declares that this SHARP Hi Fi Component System XL-HF202PH(S)/XL-HF202PH(BK)/XLHF302PH(T) is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. The declaration of conformity may be consulted at: http://www. [. . . ] —● The Numeric buttons allow you to select up to number 9. —● When selecting number 10 or higher, use the “10+” button. For example, to choose 13 1 Press the “10+” button once. For example, to choose 130 1 Press the “10+” button twice. Notes: ●● A track number higher than the number of tracks on the disc cannot be selected. —● During random play, direct search is not possible. –■ Random play To random play all tracks: Press RANDOM button on the remote control until “Random” appears. Notes: ●● If you press the button during random play, you can move to the track selected next by the random operation. However, the button does not allow you to move to the previous track. The beginning of the track being played will be located. —● In random play, the unit will select and play tracks automatically. (You cannot select the order of the tracks. ) E-12 Listening to a CD or MP3/WMA disc (continued) ■■ Repeat play Repeat play can play one track, all tracks or a programmed sequence continuously. To repeat one track: Select desired track using the Numeric buttons. Press the REPEAT button repeatedly until “Repeat One” appears. To repeat all tracks: Press the REPEAT button repeatedly until “Repeat All” appears. To repeat desired tracks: Perform steps 1 - 5 in “Programmed play” section on this page and then press the REPEAT button repeatedly until “Repeat All” appears. To repeat one folder: While in Folder mode on (MP3/WMA), press REPEAT button repeatedly until “Repeat Folder” appears. To cancel repeat play: Press the REPEAT button repeatedly until “Normal” appears and “ ” disappears. To cancel the programmed play mode: During programmed stop mode, press the (CD ) button. The display will show “Memory Clear” and all the programmed contents will be cleared. Adding tracks to the programme: If a programme has been previously stored, the “MEM” indicator will be displayed. [. . . ] ) or if it is operated incorrectly , it may malfunction. If such a problem occurs, do the following: 1 Set the unit to the stand-by mode and turn the power on again. 2 If the unit is not restored in the previous operation, unplug and plug in the unit again, and then turn the power on. Note: If neither operation above restores the unit, clear all the memory by resetting it. [. . . ]