User manual SHARP YO-480

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. [. . . ] Press TEL 2nd INDEX . Up to five names can be displayed at a time. Davis Mike Edwards Bob Editing entries To edit an entry, recall it, then press 2nd EDIT to enter the edit mode. With the cursor "s" you may type over the characters. Press INS to change the cursor to " " and you may insert new characters. After making changes, press ENTER to store the new entry. To cancel any changes, press C·CE twice before pressing ENTER . The first 18 characters of the first line of each entry are displayed. To display the first entry beginning with a particular character, press the desired character key. If there is no entry for that character, the first subsequent entry will be displayed. For example, if S or P is pressed at the left display below: NOTE: If 2nd ENTER are pressed instead of ENTER after making changes, data can be copied. (Refer to "Copying scheduled data" on page 13. ) Hamilton Olivia Louis Greg MacDonald Edith Scott Teresa Smith Robert Scott Teresa Smith Robert Weiner Mike Deleting entries Either a single entry or an entire directory can be deleted. Deleting a single entry Pressing NEXT and PREV scrolls the page forward and backward. and to To see the whole entry, move the pointer " " using select the desired entry, and press ENTER . Select the directory containing the entry to be deleted. With the cursor "s" you may type over the characters. Press INS to change the cursor to " " and you may insert new characters. After making changes, press ENTER to store the new entry. To cancel any changes, press C·CE twice before pressing ENTER . Rearranging memos In the index display the order in which memos are recalled can be changed. For example, when there are five memos stored in the order of "memo1" through "memo5", to place "memo2" after "memo4": 1. Select the MEMO mode and go to the index display. MEMO 2nd INDEX NOTE: If 2nd ENTER are pressed instead of ENTER after making changes, data can be copied. (Refer to "Copying scheduled data" on page 13. ) Deleting memos Either a single memo or the entire memo list can be deleted. 2. Move the pointer to the entry you want to move and specify it. INS ("memo2" is blinking. ) 3. Move "memo2" after "memo4". Store the new order. ENTER memo1 memo2 memo3 memo4 memo5 memo1 memo2 memo3 memo4 memo5 Deleting a single memo For example, to delete the memo "X'mas presents list": 1. Select the MEMO mode and recall the data. MEMO NEXT memo1 memo3 memo4 memo2 memo5 (Press NEXT repeatedly until the memo item "X'mas presents list" appears. ) 2. [. . . ] Remove the used battery by prying it out with a ball-point pen. 4) Do not use a mechanical pencil or sharp pointed object. Install the new battery with the (+) side facing up. Replace the battery holder cover and secure it with the screw. [. . . ]