User manual SHERWOOD VR-670

[. . . ] Introduction READ THIS BEFORE OPERATING YOUR UNIT This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. Note to CATV System Installer : This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. FCC INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Note : · Opening or closing the disc tray by force may damage it's mechanism. Note : · When you play a DVD Video that contains a menu or a MP3 disc, the menu display may appear on the TV screen. In this case, see "To start playback from the menu of DVD Video" below or "To start playback from the menu of MP3 disc" on the next page. · Example of DVD Video · Example of MP3 disc To start playback from the menu of DVD Video · Press the CURSOR button). /// buttons to select the preferred item and press the ENTER button (or PLAY/PAUSE( ) · Playback of the selected item starts. · When the selected item contains the subitems, repeat the above step until the preferred item is selected, To stop playback and return to the menu display · Press the TOP MENU or MENU button on the remote control. (Which button is pressed differs depending on the discs. ) · Playback is suspended and the menu display appears. 20 To start playback from the menu of MP3 disc In the stop mode, select the desired list mode. File list mode : It displays all the files on a disc, ignoring the folders in which they belong. · Example of folder list mode · Example of file list mode Press the CURSOR / buttons to select the preferred folder or file, then press the ENTER button. · When selecting the preferred file, playback starts from the selected file. · In the folder list mode, when selecting the preferred folder, the file menu screen of the selected folder is displayed. In this case, repeat this step to select the preferred file in its file menu. ) or BACKWARD · Each time the FORWARD SKIP( ) button is pressed, the next or previous SKIP( folder/file menu is skipped to. 2 Notes : · Depending on the MP3 disc and the condition of recording, some of MP3 discs may not be played or may be played differently. · The DVD Videos continues to rotate while the menu display appears. When no further selections are to be played, be sure to press the STOP( ) button repeatedly to enter the stop mode and to clear the menu display. · A TV screen may be burned out if a static picture is displayed for a long time in the stop or the pause mode, etc. . To prevent this, set the Screen Saver to ON (refer to "When selecting the Screen Saver" on page 35). Then, the unit automatically activates the screen saver function if a static picture, etc. Pressing any button will cancel the screen saver function and return to the previous display. · When you press a button, if the corresponding operation is prohibited by the unit or the disc, appears on your TV screen. To stop playback · When playback of DVD Video is stopped, the unit memorizes the point where the STOP( ) button was pressed(RESUME function: DVD Video only). ("R-STOP" is displayed on the unit's display when this function is activated. ) ) button again, and playback Press the PLAY/PAUSE( will resume from that point. When the STOP( ) button is pressed again, the RESUME function will be canceled and it enters stop mode. ("STOP" is displayed. ) · In case that the Last Memory is set to ON, during playback of DVD Video, even when selection of the input source changes from DVD input source or the unit is turned off, the resume function is activated, too. (Refer to "When selecting the Last Memory" on page 36. ) · When about 20 minutes elapses in the stop mode, etc. , the power is automatically turned off and it enters standby mode. (Auto power-off function) 21 ENGLISH 1 · Each time this button is pressed, the list mode changes as follows: Folder list mode : It displays the folder/file structure as they were recorded. To pause playback · DVD Video : The unit will be in the still picture mode. · CD/MP3 disc : The unit will be in the pause mode. · To return to normal playback, press the PLAY/PAUSE( ) button. ENGLISH Frame advance playback [DVD Video only] · During playback or in the still picture mode. ) button is pressed, the disc is · Each time the STEP( advanced by one frame. [. . . ] · The disc is dirty. Noise or distorted sound 51 [TUNER SECTION] PROBLEM Stations cannot be received POSSIBLE CAUSE · No antenna is connected. · The desired station frequency is not tuned in. · The antenna is in wrong position. · An incorrect station frequency has been memorized. [. . . ]