User manual SHIMANO BL-TT78

[. . . ] SI-8UN0A-002-00 General Safety Information CAUTION · Improper use of your bicycle's brake system may result in a loss of control or an accident, which could lead to a severe injury. [. . . ] Loose, worn or damaged parts may cause the bicycle to fall over and serious injury may occur as a result. We strongly recommend only using genuine Shimano replacement parts. · Read these Technical Service Instructions carefully, and keep them in a safe place for later reference. <Points to note about the handlebars> · Handle inner diameter: 19. 0 - 22. 5 mm · Handle outer diameter: 22. 2 - 24. 0 mm · Applicable handlebars: Carbon fiber handlebars (with aluminum inserts where the brake levers are installed) or aluminum handlebars * Carbon fiber handlebars without aluminum inserts where the brake levers are installed cannot be used. NOTE: · Parts are not guaranteed against natural wear or deterioration resulting from normal use. · For maximum performance we highly recommend Shimano lubricants and maintenance products. · For any questions regarding methods of handling or maintenance, please contact the place of purchase. Technical Service Instructions SI-8UN0A-002 3. Install the inner cable BL-TT78 Brake lever Outer holder In order to realize the best performance, we recommend that the following combination be used. Brake lever Caliper brake Brake cable BL-TT78 BR-7800 / BR-6600 / BR-5600 Outer casing Inner cable Installation of the brake lever 1. Pass the outer casing through the handlebar, and then adjust its length so that it will fit securely into the outer casing holder when the brake lever is installed. Be sure to leave some excess cable, even if cutting it to the full length of the handlebars. Cable hook Inner end Make sure that the inner end is firmly seated in the cable hook. Be sure to read the service instructions for the Brake System in conjunction with these service instructions. [. . . ] Phone: +1-949-951-5003 Turn the reach adjustment bolt with a flat-tipped screwdriver having a tip width of 3mm and a thickness of 0. 5mm. When installing the components to carbon frame/handle bar surfaces, verify with the manufacturer of the carbon frame/parts for their recommendation on tightening torque in order to prevent over tightening that can cause damage to the carbon material and/or under tightening that can cause lack of fixing strength for the components. Industrieweg 24, 8071 CT Nunspeet, The Netherlands Phone: +31-341-272222 3-77 Oimatsu-cho, Sakai-ku, Sakai-shi, Osaka 590-8577, Japan * Service Instructions in further languages are available at : http://techdocs. shimano. com Please note: specifications are subject to change for improvement without notice. [. . . ]