User manual SHURE UHF-R WIRELESS

[. . . ] Model UHF-R Wireless Systems User Guide Model UHF-R Wireless User Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 2010 Shure Incorporated 27NS14492 (Rev. 1) Printed in U. S. A. N108 English !Install in accordance with the manufacturer's instructions. [. . . ] Install the receivers in the location where they will be used and power them on. Mute all inputs on mixing devices connected to receivers. Turn off all bodypack or handheld transmitters for the systems you are setting up. Single Receiver Turn on potential sources of interference such as other wireless systems or devices, computers, CD players, effects processors, and digital rack equipment so they are operating as they would be during the presentation or performance. 2. Turn the Control wheel to select a group. 1. Select Radio > Scan > Chan Scan using the Navigate keys on the receiver LCD interface. 3. The display indicates that the receiver is searching. Once it has finished, it displays the selected channel. Press the flashing ENTER button to accept the suggested channel. Sync the transmitter (see page 15). With networked or dual receivers, you can take advantage of the group scan feature to set group and channel settings for all the receivers at the same time. (See page 12 for instructions on networking. ) Perform a group scan from any receiver. . . Select Radio > Scan> Group Scan using the Navigate keys on the receiver LCD interface. The display indicates that the receiver is searching (Scan In Progress). Once it has finished, it displays the group with the most open channels. If you wish, turn the Control wheel to change groups. The number of open channels for each group is displayed. Press the flashing ENTER button to set all receivers to open channels in that group. NOTE: The group scan feature only works for receivers in the same frequency band. For example, if you did a group scan on a "H4" band receiver, all "H4" band receivers would be set up, but not "J5" band receivers. Multiple Receivers--Not Networked Find the group with the most open channels. . . If your receivers are not networked (or in different bands), the group scan cannot automatically set their group and channel settings. However, you can still take advantage of the group scan feature to find the group with the most open channels and the channel scan feature to find open channels in that group. Perform a group scan using the steps for a networked receiver (above). However, make a note of the selected group before pressing the flashing ENTER button to accept it. Set the receivers to open channels in that group. . . Perform a channel scan on the remaining receivers using the steps for a single receiver (above). [. . . ] 69 & EU harmonized 854-862 & 863865 MHz Group 33 1 2 3 4 5 6 7 8 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 9 Optimized: TV Ch. 67-69 & EU harmonized 838-862 & 863-865 MHz Group 34 U. K. 69 Co-ordinate frequencies SET 1" Group 35 U. K. 69 Co-ordinate frequencies SET 2" Group 36 U. K. [. . . ]