User manual SHURE UHF-R WIRELESS SYSTEM REV 1

[. . . ] Model UHF-R® Wireless Systems User Guide Model UHF-R® Wireless Systems User Guide UR1M Micro bodyPack Transmitter ©2010 Shure Incorporated 27HK14492 (Rev. 1) Printed in U. S. A. N108 Shure UHF-R Wireless !Install in accordance with the manufacturer's instructions. DO NOT install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including ampli ers) that produce heat. [. . . ] Once it has finished, it displays the selected channel. Press the flashing ENTER button to accept the suggested channel. Sync the transmitter (see page 14). Networked or Dual Receivers With networked or dual receivers, you can take advantage of the group scan feature to set group and channel settings for all the receivers at the same time. (See page 10 for instructions on networking. ) Perform a group scan from any receiver. . . Select Radio > Scan> Group Scan using the Navigate keys on the receiver LCD interface. The display indicates that the receiver is searching (Scan In Progress). Once it has finished, it displays the group with the most open channels. If you wish, turn the Control wheel to change groups. The number of open channels for each group is displayed. Press the flashing ENTER button to set all receivers to open channels in that group. NOTE: The group scan feature only works for receivers in the same frequency band. For example, if you did a group scan on a "H4" band receiver, all "H4" band receivers would be set up, but not "J5" band receivers. Multiple Receivers--Not Networked If your receivers are not networked (or in different bands), the group scan cannot automatically set their group and channel settings. However, you can still take advantage of the group scan feature to find the group with the most open channels and the channel scan feature to find open channels in that group. Find the group with the most open channels. . . Perform a group scan using the steps for a networked receiver (above). However, make a note of the selected group before pressing the flashing ENTER button to accept it. Set the receivers to open channels in that group. . . Perform a channel scan on the remaining receivers using the steps for a single receiver (above). Make sure to select the same group for each receiver before performing the channel scan. IMPORTANT: After setting the channel for the first receiver, immediately sync the transmitter for that receiver and leave it on so that the next receiver detects that channel during its channel scan. Otherwise, all the receivers will be set to the same open channel. NOTE: Receivers in different bands (H4, J5, L3, etc. ) do not need to be set to the same group. 9 Networking Receivers Basic Network Connect receivers to an Ethernet router with DHCP service. Use Ethernet switches to extend the network for larger installations. Use the receiver's default network setting (Util > Network > Mode = DHCP). Router with DHCP Shure UHF-R Wireless Computer (optional) Accessing the Network with a Computer If you want to use the Wireless Workbench software, connect your computer to the network and install the software from the CD that came with the receiver. [. . . ] The receiver shall include dual RF meters (one for each antenna), an audio level meter, and a Networking Interface connector for computer control and monitoring. The receiver shall have a volume control and an adjustable noise squelch control. The system shall be the Shure UHF-R Wireless. Certification 120KF3E UR1, UR1M, UR2, UR4S+, UR4D+: Type Accepted under OFTA HKTA 1008 (Issue 3). Emission Designator UR4S+, UR4D+: Authorized under the Declaration Of Conformity provision of FCC Part 15. Certified under Industry Canada to RSS123 ("IC: 616A-UR4P"). [. . . ]