User manual SIEMENS ER11153NE

[. . . ] When our products are being transported, they must be provided with suitable protective packaging. However, we have reduced our packaging to the bare essentials, and the materials are all completely recyclable. You too can contribute to the conservation of the environment by depositing the packaging in the nearest recycling container. Before you get rid of an old appliance, make sure you render it useless, and then take it to a centre for the recovering recyclable materials. [. . . ] Do not install refrigerators, dishwashers, ovens and/or cookers or any laundry appliances underneath the hob. Be sure to keep minimum distances of 100 mm from the side wall and 50 mm from the back wall. The minimum width of the worktop should be 600 mm. The installation dimensions can be seen on the following page. 6 7 Chimney cooker hoods are to be installed in accordance with the installation instructions of the hood. On the furniture into which the appliance is to be installed, the plastic coating and/or veneer must have been treated with a heat-resistant adhesive, otherwise it may become distorted or peel off, especially on the narrow sides. The rough edges of the cut-out must be sealed using a watertight material. Prior to connection of the appliance, it must be checked that the appliance specifications comply with local connection requirements (gas type and pressure). Please also check for any special regulations of your local supply company. The specifications of this appliance are listed on the rating plates which are located on the underside of the gas hob. This appliance is not to be connected to the exhaust air outlet. It must be installed and connected according to the currently effective installation conditions. Your hob is pre-mounted with the connection ISO 7-1. In order to change the elbow coupling (see picture 4) Picture 4 12 13 In compliance with the currently effective regulations, the hob must be connected to the gas pipe with a stop valve. This valve must be easily accessible at all times. After connecting the unit to the gas mains always check the seal of the connection using a solution of soapy water. Using flexible pipes: · do not allow the pipes to be constricted or crushed; · the pipes must not be subjected to traction or twisting forces; · do not allow the pipes to come into contact with cutting or sharp edges, etc. . . CHANGING THE NOZZLES The burners are adaptable to different types of gas by replacing only the nozzles for the type of gas used (see data table). To access the nozzle, simply remove the cap and flame-breaker. REGULATION OF MINIMUM FROM LPG TO NG Our taps are suitable for all types of gas and are regulated at the minimum as follows: 1. Light the burner and turn the knob to the minimum position. If the flame should go out, proceed as follows: a. ) light the burner at maximum capacity (large flame) b. ) remove the knob c. ) introduce a small screwdriver in hole B on the shaft of the tap (picture 6) and unscrew the adjustment screw by two turns. d. ) replace the knob and turn to the minimum position (small flame) 2. [. . . ] - No electrical connection Solution - Check the fuse in the main fuse box and change it if necessary. - Check the main fuse box to see whether the automatic trip switch or a differential switch has tripped. - Carefully clean the spaces between the sparker and the burners. - Dry the burner covers and sparkers carefully - Make sure that the burner covers are properly seated. [. . . ]