User manual SIEMENS ER31120IL

[. . . ] 8 . 8 . 8 10 11 12 12 12 14 14 15 15 16 17 17 17 19 19 20 21 21 21 22 23 23 23 23 24 25 26 26 26 26 27 28 3 Operating instructions. . Dear customer, Congratulations on your choice and thank you for purchasing one of our appliances. This practical, modern and functional appliance is manufactured using materials of the highest quality which are subject to strict quality control checks throughout the entire manufacturing process. The appliance is meticulously tested to ensure that it meets your demands and produces perfect cooking results. [. . . ] Remove plastic cap from gas supply line prior to installation. Fit regulator (N. G. ) or a test point (Propane gas) directly to the R 1/2'' connection as per Fig. Direction of gas flow is indicated on the rear of the regulator. For position of the inlet connection refer Fig. 1. Use pipe compound or thread sealant, properly theaded pipes and careful assembly procedure so that there is no cross threading, etc. , which might cause damage or leakage. Make sure that all connections peformed are free of leakage. The manufacturer does not accept any liability for leakage on connections performed by the installer or if the L-tube is moved or twisted. Fig. 6 There are two ways to carry out the connection to the main gas line: A. The hotplate can be connected with rigid pipe as specified in AS/NZS 5601. 1 B. Flexible Hose: If installing with a hose assembly, install with a hose assembly that complies with AS/NZS 1869 (AGA Approved), 10 mm ID, class Bor D, no more than 1, 2 m long and in accordance with AS/NZS 5601. 1. Ensure that the hose does not contact the hot surfaces of the hotplate, oven, dishwasher or any other appliance that may be installed underneath or next to the hotplate. 12 Refit all the components, proceeding in the reverse order to removal. Adjustment of the taps Set the control knobs to minimum. It has a flexible rubber valve reinforcing ring. Simply press on this seal with the tip of a screwdriver to allow access to the tap adjusting screw. Fig. 13 17 Never remove the valve reinforcing ring. If the by-pass screw cannot be accessed, disassemble the glass panel and frame described in: Changing the nozzles for double-flame burners. Adjust the minimum ring setting by turning the by-pass screw using a flat head screwdriver. replace the control knob onto the spindle, light the gas and turn the control knob to the small flame position. Screw the adjustment screw anti-clockwise to estabilish a minimum stable flame position. The flame should remain alight and not burn back to the injector when the valve is turned quickcly from `Full On' to the "Minimum flame" position and back a few times. To adjust the minimum flame position for ULPG the screw must be fully tightened down clockwise. In the event of a malfunction, change the whole tap. Fig. [. . . ] Never use abrasive products, steel scourers, sharp implements, knives, etc. to remove bits of hardened food from the cooktop. If your cooktop is fitted with a glass or aluminium panel, never use a knife, scraper or similar to clean the point where it joins the metal. Do not use knives, scrapers or similar implements to clean the point where the glass meets the burner trims, the metal frames or the glass/aluminium panels, if fitted. [. . . ]