User manual SIEMENS ER326AB90A

[. . . ] This cooktop is for use with Natural Gas and propane gas Siemens - Electrogeräte GmbH Carl-Wery-Straß e 34 81739 München Cod. 9000432107 A ER926SB90A ER626PB90A ER326AB90A ER326BB90A Content Safety considerations . Installation of cooktop into the kitchen bench . Changing the nozzles of the large, medium and small buners on the cooktop . [. . . ] Primary air adjustment is not necessary with these burners. Note: it is not necessary to adjust the primary air control on these burners. Fig. 8 Changing doubleflame burner tips The glass panel and frame are fixed to the rest of the cooktop using a clip mounting system. The following steps must be taken to remove the glass panel and frame: - Remove all the burner covers and pan supports. - Release the front clip fixing the appliance to the kitchen unit by removing the screw. - Loosen the screws on the burners, Fig. 9c, and remove the control knobs from their respective housings. Fig. 9c Use the disassembly lever 483196 available from our Service Centre. To release the front clips, apply the lever in the area shown in figures 10 according to the cooktop model. Fig. 10 15 Never use the lever on glass edges which have no trim or frame!- To release the rear clips, carefully raise the entire glass panel and frame, as in Fig. 10a. Fig. 10a Changing the outer flame nozzle (Fig. 11) - Loosen the clamp screw to release the bushing by moving it backwards to access the main nozzle easily. - Remove the outer flame nozzle by turning it towards the left. - Adjust the distance of the airflow adjusting bushing L2 according to the value -Z-. 11 16 Changing the inner flame nozzle (fig. 12) - Unscrew the part M3 from the threaded part M2; to do this, hold the threaded part in the opposite direction. - Disassemble the assembly of parts M2 and M4 from part M1. - Remove the inner flame nozzle M4 from part M2. - Screw in the new inner flame nozzle M4. 12 Refit all the components, proceeding in the reverse order to removal. Adjustment of the taps Set the control knobs to minimum. It has a flexible rubber valve reinforcing ring. [. . . ] Always clean off any liquid as soon as it is spilt: you will save yourself any unnecessary effort. Grains of sand that may come from cleaning fruits and vegetables will scratch the glass surface. Melted sugar, or foods which contain a lot of sugar which may have spilt, should be cleaned off the hotplate immediately, using the glass scraper. Unsuitable products Maintenance 26 Service Fault The general electrical system is malfunctioning. Sometimes certain faults detected can be easily resolved. Before calling the Service Centre, bear in mind the following advice: Possible cause Defective fuse. [. . . ]