User manual SIEMENS GIGASET A140

[. . . ] EN Dear Customer, Gigaset Communications GmbH is the legal successor to Siemens Home and Office Communication Devices GmbH & Co. KG (SHC), which in turn continued the Gigaset business of Siemens AG. Any statements made by Siemens AG or SHC that are found in the user guides should therefore be understood as statements of Gigaset Communications GmbH. Sehr geehrte Kundin, sehr geehrter Kunde, die Gigaset Communications GmbH ist Rechtsnachfolgerin der Siemens Home and Office Communication Devices GmbH & Co. [. . . ] The operation of medical appliances may be affected. Be aware of the technical conditions within the particular environment (e. g. The handset may cause an intrusive 'hum' in hearing aids. Do not hold the handset against your ear while it is ringing (incoming call). Dispose of the battery pack and telephone in accordance with environmental regulations. Do not pollute the environment. Emergency numbers cannot be dialled if the keypad lock (page 3) is activated!Not all of the functions described in this manual are available in all countries. 2 Setting up the telephone for use Step 1: Connecting the base Opening the battery cover Press down on the battery cover below its upper end and slide the cover down. 1 2 W Connect the phone jack with the phone cord 1 and the mains units (230 V) with the power cord 2 as shown. The two cords must be plugged in at all times. Use only the mains unit supplied (see the bottom of the base). If you ever purchase another phone cord from a store, ensure that the phone conductors are correctly connected: 3-4 connection of the telephone conductors/EURO CTR37. Place the battery leads in the cable guides so that the battery cover cannot catch on the leads and damage them when it is closed. Only insert the recommended rechargeable battery pack, i. e. never use a normal battery pack as this could damage your health and cause injury. Never use non-Siemens battery chargers as this could damage the battery pack. During a call you can switch between earpiece and handsfree mode by pressing c; adjust the volume withtors. Making calls Making external calls/Ending a call External calls are calls using the public telephone network. ~ (Enter the number) The number is dialled. (Or you can first press c [dial tone] and then enter the number. ) During the call you can adjust the earpiece volume with t and s. End the call/cancel dialling: Press the end call key a. You can automatically insert a network provider prefix before any number (see Menu Tree, PRESELECT, page 9). ¢c. Using the directory and other lists Directory and speed dial list These two lists are used in the same way. Directory: Can store up to 20 numbers and associated names. Speed dial list: Can store up to 8 numbers (12 digits max. ), e. g. private phone numbers, prefixes of network providers ("Call-by-Call") etc. Press the h or C key to open the required list then press MENU. The following functions are available: EDIT ENTRY NEW ENTRY SHOW ENTRY DELETE Answering a call Your handset rings and you wish to take the call: Press the talk key c. [. . . ] flash in the Check the power conThe base is not display. Cords not routed Check cord routing (page 2). correctly Care Wipe the base station and handset with a damp cloth or an antistatic wipe. This can cause static! Authorisation This device is intended for analogue phone lines in your network. [. . . ]