User manual SIEMENS GIGASET SE567 QUICK START GUIDE

[. . . ] To connect to a USB port, complete the steps in Option B. Option A > Ethernet Installation Method If your computer does not have an Ethernet Adapter installed, install it now. Refer to your Ethernet Adapter manufacturers documentation for complete installation instructions. Connect the Gigaset® Device 1. Connect the Ethernet cable (RJ-45) to the Ethernet port on the Gigaset device (yellow port). Connect the other end to the Ethernet port on your computer. [. . . ] Browse to setup. exe on the CD and double-click it to start the program. Global network of innovation ns o are trad em arks of Siem ens AG, Germany. All other trademarks are held by their resp ve ecti . Sie ies pan com Macintosh USB Driver Installation Software Installation Before installing the software, make sure your system is running OS 8. 6 or above. This procedure will restart your computer to complete the installation. Insert the Gigaset® Installation CD into your CD-ROM drive. Open the Gigaset® icon from the desktop. Follow the directions in Read me. txt to complete the software installation. After the USB driver is installed, continue with the PC Configuration procedures described on 5 the next page. me ns For Windows: Close all applications. If not, go to "My Computer. " Right-click and open the CD drive. Double-click on setup. exe. res erv es the righ t to make changes to product specifications at Windows/Mac OS September 2006 007-SE03-001 any time out with USB Drivers ice. not Gigaset® Cop yrig ht© 200 6 SIEM ENS ed. All rights ens Siem and the me Sie log Option B> Macintosh Configuration Step 3 > Choose a Configuration Method The steps required to setup your system for using the Gigaset® depend on whether you use a PC or a Macintosh. Select the appropriate option for your system. Option A > Configure the PC 1: Configuring Windows® To setup the Gigaset® device, you must first configure your PC to obtain an IP address from a DHCP server. Follow the procedure below: Note: The following procedures are for a PC running Windows XP. Please refer to the User Guide on the CD-ROM for help configuring other operating systems. Double-click the Network Connections icon. Select Obtain an IP address automatically. Select Obtain DNS server address automatically. Click OK and exit out of the Control Panel. Configure Internet Access using the procedure that follows. Click Connect to the Internet. 2: Configuring Internet Access Next, use the procedure below to make sure your PC will use the Gigaset device (and not Dial-up Networking) when connecting to the Internet. Select Connect using a broadband connection that is always on. Configure the Gateway using the procedure Configuring the Gateway. [. . . ] You have completed installing your Gigaset device. 7 Troubleshooting LED Power Off Power is off. Green Power is on. Blinking Green N/A Blinking Red/Green Flash write in progress. Red - POST in progress. N/A Ethernet 1-4 Wireless - Power not applied. - No link. Normal operation, Link okay. DSL line is trained and ready for traffic. [. . . ]