User manual SIEMENS GIGASET 5005

[. . . ] Hang telephone on projecting screw heads. Safety precautions When installing, connecting and operating the telephone, always observe the following precautions: Only use the jacks and leads supplied. Only connect the connecting lead to the intended socket. Lay the connecting lead where it will not cause accidents. [. . . ] Press Set key, (or after the call:) replace handset. Lift handset, press repertory key. Dialling a repertory number You can also dial any additional digits. Dialling a speed dial number cD 0. . . 9 Lift handset, press speed dial key. Press speed dial number (number key). Dialling and saving numbers Dialling a number Notes on saving and deleting repertory and speed dial numbers * and # are saved co Lift handset, dial number. Last number redial The last number dialled is automatically saved. c; Lift handset, press last number redial key. Repertory and speed dial You can save 4 numbers (max. 21 digits) as repertory numbers on the 4 repertory keys : and 10 numbers as speed dial numbers on the number keys (max. 21 digits). regardless of the set dialling mode but are only dialled with DTMF dialling. The following steps delete numbers saved to the repertory or speed dial keys: The number entered is longer than 21 digits Saving a number will delete the previous content of the memory Dialling pauses One or more dialling pauses (not at 1st digit) can be entered using <. Pauses are transferred to the memory and are necessary for certain extension systems (e. g. : 0 < 2368). Dialling a dialling pause within the first 5 digits: The entire number saved is dialled, including the 2-second dialling pause. Dialling a dialling pause after the first 5 digits: The portion of the number saved after the pause is only dialled after pressing the < key. Saving (or saving with notebook function) c? either . . . Lift handset, (or with notebook function: during a call) press Set key. Press repertory key; : or . . . As repertory D0. . . 9 As speed dial Press speed dial key and speed dial number (number key); 3 GB Adjusting the telephone Setting the handset volume The handset volume can be set to 2 levels. Operation on a PABX Special functions/Recall key During an external call, you can make an enquiry or forward the call. The subsequent procedure depends on your PABX. By default, the recall key is set to flash time 1 (pulse/tone switch in "Tone 1" position). For connection to a PABX, it may be necessary to change the flash time (e. g. pulse/tone switch to "Tone 2"). To do this, please refer to the operating instructions for your PABX. E Press Handset volume control key. Mute You can deactivate the telephone's microphone. During a call: J To reactivate microphone: Press the mute key again. Press mute key. Setting the ringer You can set the ringer frequency and volume to 9 levels (factory default: level 6) or turn it off. Changing the dialling mode By default, your telephone is set to tone dialling mode (Tone 1). Depending on the dialling mode of your PABX, you may need to set the telephone to pulse dialling (DP). Slide switch on underside of unit: c? # 0. . . 9 ? Lift the handset, press the Set key. [. . . ] We, Gigaset Communications GmbH, declare that this device meets the essential requirements and other relevant regulations laid down in Directive 1999/5/CE. A copy of the 1999/5/EC Declaration of Conformity is available at this Internet address: www. gigaset. com/docs. If your telephone is not working perfectly Lift handset, no dialling tone: Is the connecting lead correctly plugged into the telephone and the telephone socket?Dialling tone audible but telephone will not dial: The connection is OK. [. . . ]