User manual SIEMENS HB 760 50F

[. . . ] There must be a gap between the interĆ mediate floors and the connecting wall of approximately 20 mm to ensure oven ventilation. Install ovens with carriages low enough to allow baking trays to be easily removed. Installing the oven in a corner into consiĆ deration. [. . . ] Installing the oven in a corner into consiĆ deration. Measurement E depends on the thickness of the front of the unit and the handle. D when Connecting the oven to the mains J The cooker may only be connected by a licensed specialist. The local electricity supplier's regulations and national regulaĆ tions apply. J The appliance must be disconnected from the mains before any installation work takes place. J The oven corresponds to safety class I and may only be used with an earth conĆ nection. j Mains connection lead: Type H05 VāVĆF or higher. The yellowĆgreen lead for the earth conĆ nection must be 10 mm longer on the side of the appliance than the other leads. wear protective gloves to prevent cuts. J The appliance power socket must be located within the shaded area B or outside of the area where the appliance will be installed. J A gap of at least 5 mm is required between the appliance and adjacent unit fronts. J If the units are not fitted, they must be secured to the wall with a standard bracket C . Removal Disconnect the cooker from the power supply. Lift the cooker slightly and pull it out compleĆ tely. 4 J If the oven has an oven carriage, this must be removed. j Insert the cooker and align centrally. [. . . ] Lift the cooker slightly and pull it out compleĆ tely. 4 J If the oven has an oven carriage, this must be removed. j Insert the cooker and align centrally. [. . . ]